أين هو فين?
•
لا يوجد رقم تعريف؟
احصل على تقارير إبيكفين
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH BI-FUEL COMPRESSED NATURAL GAS (CNG) VEHICLES. THE CNG FUEL LINE AND THE CNG HIGH PRESSURE REGULATOR COOLANT LINES CAN CONTACT OTHER FUEL (GASOLINE) AND BRAKE LINES ON THE VEHICLE. ABRASION FROM CONTACT CAN CAUSE A LEAK IN THE BRAKE PIPE, FUEL PIPE, OR BOTH.
DORMAN PRODUCTS IS RECALLING 3,900 INTERMEDIATE STEERING SHAFTS DORMAN PART NOS. 425-151, 425-152, AND 425-153, (SOLD UNDER DORMAN'S "OE SOLUTIONS" BRAND NAME), BALKAMP #'S 7-3057, 7-3058, 7-3059 (SOLD UNDER THE "NAPA" BRAND NAME), AND PLATINUM PARTS #'S 2425151, 2425152, AND 2425153 MANUFACTURED DURING THE MONTH OF SEPTEMBER 2007. THESE REPLACEMENT STEERING SHAFTS CAN BE USED ON THE VEHICLES LISTED ABOVE. THE WELD CONNECTING THE INNER TUBE TO THE OUTER TUBE MAY BE DEFECTIVE.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES WERE BUILT WITH MIS-LOCATED WELDS AT THE JOINT BETWEEN THE LEFT ROCKER PANEL INNER REINFORCEMENT AND THE BODY SIDE RING. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 214, "SIDE DOOR STRENGTH."
THESE VEHICLES WERE BUILT WITH AN INCORRECT WIPER BLADE ASSEMBLY (17" LONG INSTEAD OF 22" LONG) ON THE DRIVER'S SIDE. THIS DOES NOT COMPLY WITH FMVSS NO. 104, "WINDSHIELD WIPING AND WASHING SYSTEMS."
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
CERTAIN DELPHI AFTERMARKET FUEL PUMP MODULES / MODULE RESERVOIR ASSEMBLIES (MRA) THAT WERE SOLD FOR USE ON THE ABOVE LISTED VEHICLES. DURING PRODUCTION THE MRAS VENT AND FUEL RETURN TUBES WERE REVERSED. THIS CONDITION CAN RESULT IN THE VEHICLE NOT RUNNING CORRECTLY (IDLE ROUGH AND/OR STALL) DUE TO AN OVERLY RICH FUEL BLEND OR THE VEHICLE'S EVAPORATIVE EMISSION CARBON CANISTER MAY LEAK FUEL.
CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.
ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE COMPACT SPARE TIRE ASSEMBLIES WERE ASSEMBLED WITH INCORRECT RIMS. IF THE SPARE TIRE IS UNDERINFLATED, THE BEAD CAN SEPARATE FROM THE RIM CAUSING A RAPID LOSS OF AIR. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 110, "TIRE SELECTION AND RIMS."
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
اكتشف نصائح الخبراء والنصائح والأخبار حول شراء المركبات المستعملة وصيانتها.
نقدم لك فيما يلي كل ما تحتاج معرفته حول شاحنة تسلا، مثل التاريخ المتوقع لإطلاق...
اقرأ أكثر
سيخبرك فريقنا عن تتبع لوحة الترخيص الخاصة بك
اقرأ أكثر
اقرأ هذه المقالة لاكتشاف كيفية تحديد سيارة جديدة أو مستعملة
اقرأ أكثر
