أين هو فين?
•
لا يوجد رقم تعريف؟
احصل على تقارير إبيكفين
THESE VEHICLES WERE BUILT WITH OVERTORQUED DRIVE AXLE SPINDLE NUTS. THIS CONDITION CAN CAUSE EXCESSIVE LOADS ON THE SPINDLE NUT AND DRIVE AXLE RESULTING IN FAILURE OF THE DRIVE AXLE OR THE SPINDLE NUT. FAILURE OF EITHER OF THESE COMPONENTS CAN RESULT IN SEPARATION OF THE STEERING KNUCKLE TIRE-WHEEL ASSEMBLY FROM THE DRIVE AXLE.
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
THE SUSPENSION SUPPORT ASSEMBLIES DO NOT MEET GENERAL MOTORS CORPORATION'S SPECIFICATION FOR WELD INTEGRITY AND THE AFFECTED WELD CAN FAIL CAUSING THE FRONT OF THE CONTROL ARM TO SEPARATE FROM THE SUSPENSION SUPPORT ASSEMBLY.
THE SUSPENSION SUPPORT ASSEMBLIES DO NOT MEET GENERAL MOTORS CORPORATION'S SPECIFICATION FOR WELD INTEGRITY AND THE AFFECTED WELD CAN FAIL CAUSING THE FRONT OF THE CONTROL ARM TO SEPARATE FROM THE SUSPENSION SUPPORT ASSEMBLY.
THE SECOND ROW, RIGHT HAND SHOULDER BELT CAN BECOME "PINCHED" BETWEEN THE SEAT AND THE DOOR FRAME PILLAR TRIM. THE SHOULDER BELT MAY NOT RETRACT PROPERLY, WHICH DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION." THE 1994 VEHICLES HAVE AN OPTIONAL INTEGRAL (BUILT IN) CHILDSEAT INSTALLED NEXT TO THE POWER SLIDING SIDE DOOR. THE 1993 INVOLVED VEHICLES HAVE STANDARD SEATS IN THAT SAME POSITION.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
THE THIRD ROW SAFETY BELT RETRACTORS MAY BE INSTALLED INCORRECTLY AND MAY LOCK-UP WHEN THE VEHICLE IS ON SLOPES OF LESS THAN 15 DEGREES, WHICH DOES NOT COMPLY WITH FMVSS NO. 209, "SEAT BELT ASSEMBLIES."
THE FUEL TANK ATTACHMENT STRAP FASTENERS WERE NOT PROPERLY TIGHTENED. THE FASTENERS CAN COMPLETELY DETACH, EVENTUALLY ALLOWING THE FUEL TANK TO SAG AND THE BOTTOM OF THE TANK TO STRIKE THE ROADWAY.
اكتشف نصائح الخبراء والنصائح والأخبار حول شراء المركبات المستعملة وصيانتها.
سيخبرك فريقنا بشأن وضع ميزانية لمدفوعات السيارات الجديدة
اقرأ أكثر
هنا سنقدم لك دليلًا حول عمليات نقل تأمين السيارة
اقرأ أكثر
في هذه المقالة، نقدم معلومات قيمة حول شراء سيارة بدون سند ملكية.
اقرأ أكثر
