أين هو فين?
•
لا يوجد رقم تعريف؟
احصل على تقارير إبيكفين
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
SEVERE BRAKE CHATTER MAY CAUSE THE BRAKE CHAMBER MOUNTING BRACKETS ON EITHER SIDE TO DEVELOP CRACKS IN THE WELD AREA WHERE THE S-CAM SHAFT TUBE ATTACHES TO THE CHAMBER SUPPORT SECTION. CONSEQUENCE OF DEFECT: BRACKETS CAN BREAK, RESULTING IN LOSS OF BRAKING ABILITY AT THE FRONT WHEEL, AND POSSIBLY RESTRICT STEERING, WHICH COULD LEAD TO A VEHICLE CRASH WITHOUT PRIOR WARNING.
IN SOME 16 X 6 DISC WHEELS A MANUFACTURING DEFECT MAY CAUSE THE WHEELS TO CRACK IN THE DROP CENTER PORTION OF THE RIM. IF THE CRACK WERE TO OCCUR ON A WHEEL WITH A TUBE TYPE TIRE MOUNTED TO IT, AND CONTINUED TO GO UNDETECTED, THE WHEEL COULD SPLIT, RESULTING IN A RAPID LOSS OF AIR FROM THE TIRE.
IN SOME 16 X 6 DISC WHEELS A MANUFACTURING DEFECT MAY CAUSE THE WHEELS TO CRACK IN THE DROP CENTER PORTION OF THE RIM. IF THE CRACK WERE TO OCCUR ON A WHEEL WITH A TUBE TYPE TIRE MOUNTED TO IT, AND CONTINUED TO GO UNDETECTED, THE WHEEL COULD SPLIT, RESULTING IN A RAPID LOSS OF AIR FROM THE TIRE.
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
ATTACHING BOLTS WERE MISTAKENLY COATED WITH A SLIPPERY MATERIAL DURING PRODUCTION. THIS MATERIAL WILL ACT AS A LUBRICANT AND BOLTS MAY LOOSEN AND EVENTUALLY FALL OFF.
THE METAL FLOOR PAN ANCHOR BAR COULD FATIGUE AND BREAK AROUND THE LEFT FRONT OUTER SEAT ADJUSTER STUD OF THE DRIVERS SEAT, ALLOWING THE STUD TO SEPARATE FROM THE FLOOR PAN ANCHOR BAR.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
THE VEHICLES WERE ASSEMBLED WITHOUT THE RETAINING CLIP WHICH IS NEEDED TO KEEP THE CLUTCH CABLE FROM CONTACTING THE MASTER CYLINDER BRAKE PIPE. OVER AN EXTENDED TIME, THE CLUTCH CABLE COULD RUB THROUGH THE MASTER CYLINDER BRAKE PIPE, RESULTING IN A BRAKE FLUID LEAK AND LOSS OF FRONT BRAKES.
THE INSULATION OF THE BATTERY CABLE, BECAUSE OF ITS POSITION, RUBS AGAINST SOME OF THE ENGINE WIRING COMPONENTS. ONCE THE INSULATION IS WORN THROUGH, THE BATTERY COULD RAPIDLY DISCHARGE.
اكتشف نصائح الخبراء والنصائح والأخبار حول شراء المركبات المستعملة وصيانتها.
في هذه المقالة ، وصفنا ما إذا كان من الممكن الاستفادة من شراء سيارة إنقاذ.
اقرأ أكثر
في حال كانت ميزانيتك محدودة، يمكنك أن تشتري سيارة رخيصة مستعملة أو جديدة. اطلع...
اقرأ أكثر
في الآونة الأخيرة ، تجعل بعض العوامل بعض الناس يفضلون علبة التروس اليدوية على...
اقرأ أكثر