CHEVROLET Recall Check

الاستدعاء#:

82V021000

تاريخ الاستدعاء:

1982-03-12

المكون (المكونات):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY: FILLER PIPE AND CAP

UNDER CERTAAIN CONDITIONS, THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND FUEL TANK FILLER VENT PIPE COULD FRACTURE. THE FRACTURE OF THESE CLAMPS COULD CAUSE FUEL LEAKAGE AT ANY OF THE FOUR PIPE TO HOSE CONNECTIONS. LEAKAGE CAN OCCUR DURING REFUELING, OR WHILE DRIVING, IF THE FUEL TANK IS ABOVE 3/4 FULL.

الاستدعاء#:

08E050000

تاريخ الاستدعاء:

2008-08-14

المكون (المكونات):

EXTERIOR LIGHTING: HEADLIGHTS

K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

الاستدعاء#:

83V007000

تاريخ الاستدعاء:

1983-02-04

المكون (المكونات):

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: HOSES, LINES/PIPING, AND FITTINGS

REAR BRAKE HOSES MAY HAVE BEEN MANUFACTURED INCORRECTLY WHEN THE METAL END FITTINGS WERE INSTALLED. SOME REAR BRAKE HOSES MAY SEPARATE FROM THE METAL END FITTINGS WHEN SUBJECTED TO THE PULLING FORCE SPECIFIED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES".

الاستدعاء#:

83V007000

تاريخ الاستدعاء:

1983-02-04

المكون (المكونات):

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: HOSES, LINES/PIPING, AND FITTINGS

REAR BRAKE HOSES MAY HAVE BEEN MANUFACTURED INCORRECTLY WHEN THE METAL END FITTINGS WERE INSTALLED. SOME REAR BRAKE HOSES MAY SEPARATE FROM THE METAL END FITTINGS WHEN SUBJECTED TO THE PULLING FORCE SPECIFIED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES".

الاستدعاء#:

07E088000

تاريخ الاستدعاء:

2007-10-30

المكون (المكونات):

EQUIPMENT

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

الاستدعاء#:

82V128000

تاريخ الاستدعاء:

1982-12-17

المكون (المكونات):

WHEELS: LUGS/NUTS/BOLTS/STUDS

ON THE INVOLVED VEHICLES, THE REAR BRAKE DRUM BALANCE WEIGHTS MAY INTERFERE WITH THE ALUMINUM WHEELS. THIS CONTACT COULD CAUSE THE WHEEL LUG NUTS TO LOOSEN, LEADING TO WHEEL STUD FAILURE. THIS COULD ALLOW SEPARATION OF THE WHEEL AND TIRE FROM THE VEHICLE.

الاستدعاء#:

03E032000

تاريخ الاستدعاء:

2003-05-16

المكون (المكونات):

SERVICE BRAKES, AIR: DISC: CALIPER

REMANUFACTURERD REAR BRAKE CALIPERS, PART NOS. 18-7019, 18-7020, 16-7019, AND 16-7020, MANUFACTURED FROM FEBRUARY 1, 2002, TO APRIL, 25, 2003., AND FOR USE ON 1965 THRU 1982 CHEVROLET CORVETTES. THE SUBJECT BRAKE CALIPERS WERE MANUFACTURED USING IMPROPERLY MANUFACTURED PISTON SEALS. THESE SEALS ARE INTENDED TO PREVENT FLUID LEAKAGE BETWEEN THE CALIPER HOUSING AND THE PISTONS. THESE BRAKE CALIPERS ARE FOR USE ONLY ON 1965 THRU 1982 CHEVROLET CORVETTE VEHICLES. THIS RECALL DOES NOT INVOLVE GENERAL MOTORS CORPORATION OR ANY OF ITS PRODUCTS.

الاستدعاء#:

82V128000

تاريخ الاستدعاء:

1982-12-17

المكون (المكونات):

WHEELS: LUGS/NUTS/BOLTS/STUDS

ON THE INVOLVED VEHICLES, THE REAR BRAKE DRUM BALANCE WEIGHTS MAY INTERFERE WITH THE ALUMINUM WHEELS. THIS CONTACT COULD CAUSE THE WHEEL LUG NUTS TO LOOSEN, LEADING TO WHEEL STUD FAILURE. THIS COULD ALLOW SEPARATION OF THE WHEEL AND TIRE FROM THE VEHICLE.

الاستدعاء#:

83V045000

تاريخ الاستدعاء:

1983-05-18

المكون (المكونات):

POWER TRAIN: DRIVELINE: DIFFERENTIAL UNIT

THE LOCKING SCREW THAT RETAINS THE PINION SHAFT IN PLACE IN THE DIFFERENTIAL COULD COME LOOSE. THE PINION SHAFT TURNS THE GEARS INSIDE THE DIFFERENTIAL THAT ROTATE THE DRIVE AXLES AND REAR WHEELS. IF THE LOCKING SCREW COMES LOOSE, IT COULD DAMAGE OTHER COMPONENTS OR JAM IN THE GEARS. IF THE PINION SHAFT COMES LOOSE, THE REAR WHEELS MAY NO LONGER POWER THE VEHICLE.

الاستدعاء#:

83V045000

تاريخ الاستدعاء:

1983-05-18

المكون (المكونات):

POWER TRAIN: DRIVELINE: DIFFERENTIAL UNIT

THE LOCKING SCREW THAT RETAINS THE PINION SHAFT IN PLACE IN THE DIFFERENTIAL COULD COME LOOSE. THE PINION SHAFT TURNS THE GEARS INSIDE THE DIFFERENTIAL THAT ROTATE THE DRIVE AXLES AND REAR WHEELS. IF THE LOCKING SCREW COMES LOOSE, IT COULD DAMAGE OTHER COMPONENTS OR JAM IN THE GEARS. IF THE PINION SHAFT COMES LOOSE, THE REAR WHEELS MAY NO LONGER POWER THE VEHICLE.