1995 MITSUBISHI GALANT Recall Check

الاستدعاء#:

00V421001

تاريخ الاستدعاء:

2000-12-18

المكون (المكونات):

SUSPENSION: FRONT: CONTROL ARM: LOWER BALL JOINT

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.

الاستدعاء#:

00V237000

تاريخ الاستدعاء:

2000-08-28

المكون (المكونات):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY

VEHICLE DESCRIPTION: PASSENGER VEHICLES. CRACKS CAN OCCUR IN THE TOP OF THE FUEL TANK DUE TO AN IMPROPER SPOT WELD ON THE BAFFLE PLATE TO THE TOP PORTION OF THE FUEL TANK.

الاستدعاء#:

98V212000

تاريخ الاستدعاء:

1998-09-09

المكون (المكونات):

EXTERIOR LIGHTING: TAIL LIGHTS: SWITCH

VEHICLE DESCRIPTION: PASSENGER VEHICLES. WHEN THE STOP LAMP SWITCH WAS ASSEMBLED, GREASE WAS INADVERTENTLY APPLIED TO THE CONTACT POINT. THIS CAN CAUSE THE CONTACT POINT TO HEAT UP CAUSING INTERNAL OPERATION ELEMENTS TO MELT ALLOWING THE SWTICH TO BECOME STUCK IN ON OR OFF POSITION.

الاستدعاء#:

99V066001

تاريخ الاستدعاء:

1999-04-26

المكون (المكونات):

SUSPENSION: FRONT: CONTROL ARM: LOWER BALL JOINT

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE.

الاستدعاء#:

99V066002

تاريخ الاستدعاء:

1999-04-26

المكون (المكونات):

SUSPENSION: FRONT: CONTROL ARM: LOWER BALL JOINT

VEHICLE DESCRIPTION: PASSENGER VEHICLES BUILT IN JAPAN. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE.

الاستدعاء#:

07E055000

تاريخ الاستدعاء:

2007-07-26

المكون (المكونات):

FUEL SYSTEM, GASOLINE: DELIVERY: FUEL PUMP

CERTAIN AIRTEX FUEL PUMP MODULE ASSEMBLIES, P/N E7081H, SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE WALL OF THE FLARED FITTING OF THE FUEL PUMP IS NOT THICK ENOUGH TO PREVENT THE MATING THREADED FITTINGS FROM BOTTOMING OUT BEFORE AN ADEQUATE SEAL IS ACHIEVED. THIS CONDITION MAY RESULT IN LEAKAGE OF FUEL AT THE CONNECTION OF THE VEHICLE FUEL LINE AND THE FUEL PUMP MODULE ASSEMBLY.