أين هو فين?
•
لا يوجد رقم تعريف؟
احصل على تقارير إبيكفين
THE INVOLVED VEHICLES MAY HAVE BEEN PRODUCED WITH REAR AXLE SHAFTS (RIGHT OR LEFT) THAT DID NOT RECEIVE PROPER HEAT TREATMENT OF THE BEARING JOURNALS.
THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT THE MIDSHIP FUEL TANK PROTECTIVE SHIELDS. AS A RESULT, THEY DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", DUE TO EXCESSIVE FUEL SPILLAGE UPON FRONTAL IMPACT.
THE OPTIONAL TANDEM SUSPENSION ASSEMBLY MAY HAVE BEEN INSTALLED USING A STANDARD BEAM END ADAPTER KIT, RATHER THAN THE REQUIRED SPECIAL KIT. PROGRESSIVE DETERIORATION COULD OCCUR TO THE ADAPTER TO BEAM END BUSHING JOINT, POSSIBLY RESULTING IN FRACTURE OF THE BEAM TO AXLE ATTACHING BOLTS.
THE INVOLVED VEHICLES MAY HAVE BEEN PRODUCED WITH REAR AXLE SHAFTS (RIGHT OR LEFT) THAT DID NOT RECEIVE PROPER HEAT TREATMENT OF THE BEARING JOURNALS.
THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT THE MIDSHIP FUEL TANK PROTECTIVE SHIELDS. AS A RESULT, THEY DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", DUE TO EXCESSIVE FUEL SPILLAGE UPON FRONTAL IMPACT.
THE OPTIONAL TANDEM SUSPENSION ASSEMBLY MAY HAVE BEEN INSTALLED USING A STANDARD BEAM END ADAPTER KIT, RATHER THAN THE REQUIRED SPECIAL KIT. PROGRESSIVE DETERIORATION COULD OCCUR TO THE ADAPTER TO BEAM END BUSHING JOINT, POSSIBLY RESULTING IN FRACTURE OF THE BEAM TO AXLE ATTACHING BOLTS.
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
WITH THE ENGINE OPERATING AT HIGH SPEED, THE PLASTIC ENGINE FAN FINGER GUARDS MAY CONTACT THE ENGINE FAN AND BREAKAGE OF THE GUARD MAY OCCUR. THIS COULD CAUSE FRAGMENTS OF THE FINGER GUARD TO SCATTER.
THE TILT STEERING COLUMNS ON THE INVOLVED VEHICLES CONTAIN IN-PROCESS TEMPORARY ALIGNMENT PINS RATHER THAN THE PERMANENT PRESS-FIT PIVOT PINS. THE TEMPORARY PINS ARE SLIGHTLY UNDERSIZED AND COULD SEPARATE FROM THE STEERING COLUMN DURING VEHICLE OPERATION. THIS CAN CAUSE STEERING WHEEL LOCKUP.
اكتشف نصائح الخبراء والنصائح والأخبار حول شراء المركبات المستعملة وصيانتها.
تعرف على كل ما يخص أفخم ماركات وموديلات السيارات لعام 2023.
اقرأ أكثر
سيخبرك فريقنا عن تتبع لوحة الترخيص الخاصة بك
اقرأ أكثر
تحقق من هذا المنشور لاختيار سيارة صغيرة يمكن الاعتماد عليها في عام 2023.
اقرأ أكثر