أين هو فين?
•
لا يوجد رقم تعريف؟
احصل على تقارير إبيكفين
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
ON CERTAIN MINI VANS EQUIPPED WITH A FOLDING THIRD ROW REAR SEAT, WHEN THE THIRD ROW SEAT IS RAISED FROM ITS STOWED POSITION, IT ENGAGES STRIKER BRACKETS, ONE ON EACH SIDE OF THE SEAT CUSHION. THE FOLD-AWAY STRIKER LOOP IS WELDED TO A MOUNTING BRACKET. THE STRIKER MAY BECOME DETACHED FROM ITS MOUNTING BRACKET DUE TO A BROKEN WELD AT THE POINT OF ATTACHMENT TO THE BRACKET.
ON CERTAIN MINIVANS EQUIPPED WITH A POWER SLIDING DOOR(S), AT AN AMBIENT TEMPERATURE BELOW APPROXIMATELY 40 DEGREES FAHRENHEIT, THE ACTUATOR FOR THE POWER SLIDING DOOR(S) MAY EXPERIENCE BINDING DUE TO AN OUT-OF-SPECIFICATION CONDITION. IN ORDER TO OPEN, CLOSE OR REVERSE A POWER SLIDING DOOR, THE SHIFT SELECTOR LEVER MUST BE IN "PARK." IF THE ACTUATOR IS EXPERIENCING BINDING AND THE DRIVER SHIFTS THE VEHICLE OUT OF "PARK" WHILE A POWER SLIDING DOOR IS STILL CLOSING, THE DOOR LATCHES MAY NOT ENGAGE.
CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE ADVANCED AIR BAG REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." THE AIR BAG FOR THE FRONT PASSENGER SEAT IS TO BE TURNED OFF (SO THAT IT DOES NOT INFLATE) WHEN CERTAIN OCCUPANTS, SUCH AS SMALL CHILDREN, ARE IN THE FRONT SEAT.
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
ON CERTAIN MINI VANS EQUIPPED WITH A FOLDING THIRD ROW REAR SEAT, WHEN THE THIRD ROW SEAT IS RAISED FROM ITS STOWED POSITION, IT ENGAGES STRIKER BRACKETS, ONE ON EACH SIDE OF THE SEAT CUSHION. THE FOLD-AWAY STRIKER LOOP IS WELDED TO A MOUNTING BRACKET. THE STRIKER MAY BECOME DETACHED FROM ITS MOUNTING BRACKET DUE TO A BROKEN WELD AT THE POINT OF ATTACHMENT TO THE BRACKET.
VEHICLE DESCRIPTION: MINI VANS. THESE VEHICLES MAY HAVE THE PLASTIC TRIM COVER AROUND THE BASE OF THE FRONT SEAT SAFETY BELT BUCKLE TRAPPED BETWEEN THE SHOULDER OF THE RESTRAINT ANCHORAGE BOLT AND THE SEAT PEDESTAL. THIS COULD EVENTUALLY ALLOW THE SEAT BELT BUCKLE BOLT TO LOOSEN.
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."
VEHICLE DESCRIPTION: MINI VANS. ONE OR MORE OF THE FIVE BOLTS THAT MOUNT THE RACK AND PINION STEERING GEAR TO THE VEHICLE MAY HAVE BEEN INCORRECTLY TIGHTENED.
اكتشف نصائح الخبراء والنصائح والأخبار حول شراء المركبات المستعملة وصيانتها.
على الرغم من أننا لا نريد أن نخبرك ما إذا كان الحصول على ضمان سيارة مستعملة خي...
اقرأ أكثر
ستخبرك مقالتنا بالتفصيل ما الذي تفحصه عمليات فحص السيارة.
اقرأ أكثر
مواصلة القراءة لاكتشاف بعض نصائح القيادة الآمنة الثاقبة للسائقين الجدد.
اقرأ أكثر
