2004 BMW 6 SERIES Recall Check

Número de llamada a revisión:

04V344000

Fecha de retirada:

2004-07-14

Componentes:

POWER TRAIN: AUTOMATIC TRANSMISSION: CONTROL MODULE (TCM/PCM/TECM)

ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 8 AND 12 CYLINDER ENGINES, THE DIGITAL ENGINE MANAGEMENT CONTROL (EMC) UNITS WERE NOT PRODUCED ACCORDING TO SPECIFICATIONS.

Número de llamada a revisión:

04V303000

Fecha de retirada:

2004-06-25

Componentes:

FUEL SYSTEM, GASOLINE

ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 8-CYLINDER ENGINES, A CIRCULAR RETENTION CLIP AT THE QUICK-RELEASE COUPLING ALONG THE FUEL SUPPLY LINE WAS INADVERTENTLY NOT INSTALLED.

Número de llamada a revisión:

10V446000

Fecha de retirada:

2010-10-01

Componentes:

SERVICE BRAKES, HYDRAULIC: POWER ASSIST: VACUUM

BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, 6-SERIES, AND MODEL YEAR 2002-2008 7-SERIES VEHICLES. A CHECK VALVE OF THE BRAKE VACUUM PUMP MAY LEAK A SMALL AMOUNT OF LUBRICATING OIL. OVER TIME THIS COULD RESULT IN CONTAMINATION OF THE BRAKE BOOSTER.

Número de llamada a revisión:

12E029000

Fecha de retirada:

2012-08-14

Componentes:

ENGINE AND ENGINE COOLING: COOLING SYSTEM: FAN

This recall involves aftermarket parts sold by Valeo. Valeo is recalling certain engine cooling fans, part numbers 696121, 696273, and 696275, used as service replacement parts for model year 2008-2011 BMW 1-Series, 2006-2011 BMW 3-Series, 2000-2009 BMW 5-Series, 2004-2005 BMW 6-Series, and 2006-2007 BMW 7-Series vehicles. A metal-oxide semiconductor may overheat due to insufficient screwing of the semiconductor on the aluminum heat sink. This primary failure could cause adjacent components on the fan assembly motor circuit board to overheat and short.

Número de llamada a revisión:

12V126000

Fecha de retirada:

2012-03-26

Componentes:

ELECTRICAL SYSTEM: 12V/24V/48V BATTERY: CABLES

BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, MODEL YEAR 2004-2010 6-SERIES, MODEL YEAR 2006-2010 M5, AND MODEL YEAR 2007-2010 M6 VEHICLES. THE INSULATED BULKHEAD CONNECTOR FOR THE POSITIVE BATTERY CABLE MAY HAVE BEEN INCORRECTLY ATTACHED TO THE TRUNK FLOOR PANEL, WHICH CAN LEAD TO A LOOSENING OF THE BOLT CONNECTION. AS IT LOOSENS, AN INCREASE IN ELECTRICAL RESISTANCE AT THIS CABLE CONNECTION IS POSSIBLE AND COULD CAUSE THE CABLE CONNECTION TO OVERHEAT.