2001 CHRYSLER SEBRING Recall Check

Número de llamada a revisión:

01V005002

Fecha de retirada:

2001-01-11

Componentes:

SEATS

VEHICLE DESCRIPTION: PASSENGER VEHICLES. A NUMBER OF INCORRECT DRIVER SIDE SEAT MOUNTING BOLTS WERE INSTALLED INTO VEHICLES.

Número de llamada a revisión:

01V011002

Fecha de retirada:

2001-01-17

Componentes:

POWER TRAIN: AUTOMATIC TRANSMISSION: COOLING UNIT AND LINES

VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. A HOSE MANUFACTURING PROCESS ALLOWED THE REINFORCEMENT YARD TO BREACH THE INNER LAYER OF SOME AUTOMATIC TRANSMISSION HOSES WEAKENING THE INNER WALL WHICH COULD RESULT IN LEAKAGE OF THE AUTOMATIC TRANSMISSION FLUID.

Número de llamada a revisión:

00V299002

Fecha de retirada:

2000-10-19

Componentes:

ENGINE AND ENGINE COOLING: ENGINE

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE HARNESS FOR THE CRANKSHAFT POSITION SENSOR COULD COME IN CONTACT WITH A NEW PROTECTIVE SHIELD CAUSING A GROUNDED CIRCUIT.

Número de llamada a revisión:

00V278000

Fecha de retirada:

2000-09-22

Componentes:

STRUCTURE: FRAME AND MEMBERS: UNDERBODY SHIELDS

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THROUGH DEGRADATION OF THE BOND BETWEEN THE SILENCER PAD AND A SHEET METAL PANEL (QUARTER INNER UPPER), THE PAD MAY FALL ONTO THE MAP LIGHT LOCATED IN THE REAR SEATING AREA NEAR THE C-PILLAR TRIM PANEL (LH AND RH). THIS CONTACT COULD CAUSE THE PAD TO MELT, CREATING A HOT SMELL AND/OR SMOKE DURING LONG PERIODS OF ILLUMINATION.

Número de llamada a revisión:

00V320002

Fecha de retirada:

2000-10-27

Componentes:

FUEL SYSTEM, GASOLINE: DELIVERY: HOSES, LINES/PIPING, AND FITTINGS

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE OUTER LAYER ONLY OF THIS 3-LAYER FUEL RETURN HOSE DOES NOT CONTAIN THE DESIRED OZONE PROTECTION DUE TO A PROCESSING ERROR.

Número de llamada a revisión:

00V366000

Fecha de retirada:

2000-11-15

Componentes:

CHILD SEAT

VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES, PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." SOME OF THE OWNER'S MANUALS FOR THESE VEHICLES ARE MISSING INSTRUCTIONS THAT PROVIDE A STEP-BY-STEP PROCEDURE, INCLUDING DIAGRAMS, FOR PROPERLY ATTACHING A CHILD RESTRAINT SYSTEM'S TETHER STRAP TO THE TETHER ANCHORAGE.

Número de llamada a revisión:

00V306000

Fecha de retirada:

2000-10-24

Componentes:

AIR BAGS: FRONTAL

VEHICLE DESCRIPTION: PASSENGER VEHICLES. PASSENGER AIR BAGS WERE BUILT WITH SUSPECT ALUMINUM EXTRUSION SECTIONS WHICH MAY NOT RETAIN THE AIR BAG DOOR DURING AN AIR BAG DEPLOYMENT EVENT.

Número de llamada a revisión:

07E023000

Fecha de retirada:

2007-03-29

Componentes:

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: MASTER CYLINDER

CERTAIN CARDONE MASTER CYLINDERS WITH PART NUMBERS 10-2925, 10-2987, 10-2987MZA, 10-3083, 11-3015, 11-3042, 11-3044, 11-3045, 11-3047, 11-3064, AND 11-3156, AND WITH DATE CODES LOWER THAN DCA7078 SOLD AS REPLACEMENT EQUIPMENT FOR USE ON THE VEHICLES LISTED ABOVE. THE SEAL ON MASTER CYLINDER CAN FAIL AND LEAK BRAKE FLUID.

Número de llamada a revisión:

09E056000

Fecha de retirada:

2009-10-13

Componentes:

SUSPENSION: FRONT: CONTROL ARM: LOWER BALL JOINT

QUALIS AUTOMOTIVE IS RECALLING CERTAIN AFTERMARKET BALL JOINTS SOLD FOR USE ON CERTAIN PASSENGER VEHICLES. THE SOCKET MAY HAVE BEEN EXCESSIVELY HARDENED WHICH COULD CAUSE IT TO CRACK NEAR THE RETAINING RING GROOVE ALLOWING THE BALL STUD TO SEPARATE UNDER IMPACT LOAD. THE SUBJECT BALL JOINTS WERE SOLD AS FOUR PART NUMBERS, D10945, D10946, G10945, AND G10946. THE AFFECTED CONTROL ARMS, D10945 AND D10946, ARE STAMPED WITH THE FOLLOWING DATES ON THE BALL JOINTS: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, AND 116609. THE G10945 AND G10946 ARE THE SAME PART AS THE D10945 AND D10946 RESPECTIVELY. THEY ARE LABELED DIFFERENTLY DEPENDING ON THE AFTERMARKET CUSTOMER.

Número de llamada a revisión:

09E012000

Fecha de retirada:

2009-04-07

Componentes:

EXTERIOR LIGHTING

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.