Verificación de retiro del mercado MAZDA 626 1999

Número de llamada a revisión:

00V074000

Fecha de retirada:

2000-03-13

Componentes:

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: MASTER CYLINDER

VEHICLE DESCRIPTION: PASSENGER VEHICLES. CERTAIN RESERVOIR TANK CAPS ON THE BRAKE MASTER CYLINDER WERE PRODUCED WITH A WORN OUT DIE AND LACK VENTILATION HOLES. AS A RESULT, THE PRESSURE IN THE RESERVOIR TANK CAN DROP GRADUALLY AS THE BRAKE PAD OR SHOE WEARS AND AMBIENT TEMPERATURE DROPS. ALSO, THE PRESSURE COULD REACH A POINT THAT THE BRAKE CALIPER AND DRUM CYLINDER ARE PULLED BACK BY THE VACUUM IN THE RESERVOIR TANK WHEN THE VEHICLE IS PARKED FOR A LONG TIME.

Número de llamada a revisión:

00V134000

Fecha de retirada:

2000-05-10

Componentes:

ENGINE AND ENGINE COOLING: ENGINE

VEHICLE DESCRIPTION: PASSENGER VEHICLES. AN EXTERNAL SPRING IN THE TIMING BELT TENSIONER COULD BREAK.

Número de llamada a revisión:

05E065000

Fecha de retirada:

2005-10-06

Componentes:

FUEL SYSTEM, GASOLINE

CERTAIN SPX FILTRAN FUEL FILTERS WITH A 45-DEGREE ANGLE INLET TUBE, MODEL 800F350-S1, SOLD AS REPLACEMENT FILTERS FOR 1993-1997 FORD PROBE,1993-2001 MAZDA 626 AND MX-6, AND 1983-1994 LOYAL, 3-DOOR COUPE, HATCHBACK, SEDAN, WAGON, BRAT, DL, GL, GL-10, RX, XT, AND XT6 PASSENGER VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. CERTAIN SPX FILTRAN FUEL FILTERS WITH A 90-DEGREE ANGLE INLET TUBE, MODEL 800F300-S2, SOLD AS REPLACEMENT FILTERS FOR 19983-1994 SUBARU VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. FUEL MAY LEAK FROM THE FILTER DUE TO NON-CONFORMING BRAZING WELDS WHERE THE INLET TUBE IS CONNECTED TO THE FILTER CAN.

Número de llamada a revisión:

09E012000

Fecha de retirada:

2009-04-07

Componentes:

EXTERIOR LIGHTING

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.