1994 MAZDA MX 6 Recall Check

Número de llamada a revisión:

99I005000

Fecha de retirada:

2000-02-17

Componentes:

POWER TRAIN: MANUAL TRANSMISSION

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE SPEEDOMETER GEAR SET CAN FAIL. SYMPTOMS INCLUDE AN INOPERATIVE SPEEDOMETER, SEVERE LACK OF POWER, AND/OR A TRANSMISSION WHICH STAYS IN THIRD GEAR. IN SOME CASES, THE "OD OFF" LIGHT MAY ALSO FLASH.

Número de llamada a revisión:

99V358000

Fecha de retirada:

2000-01-10

Componentes:

EXTERIOR LIGHTING: HEADLIGHTS: SWITCH

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE HEADLIGHT WIRE THAT RUNS THROUGH THE TURN SIGNAL LEVER CAN FAIL AT THE POINT WHERE IT IS SOLDERED TO THE HEADLIGHT SWITCH.

Número de llamada a revisión:

05E065000

Fecha de retirada:

2005-10-06

Componentes:

FUEL SYSTEM, GASOLINE

CERTAIN SPX FILTRAN FUEL FILTERS WITH A 45-DEGREE ANGLE INLET TUBE, MODEL 800F350-S1, SOLD AS REPLACEMENT FILTERS FOR 1993-1997 FORD PROBE,1993-2001 MAZDA 626 AND MX-6, AND 1983-1994 LOYAL, 3-DOOR COUPE, HATCHBACK, SEDAN, WAGON, BRAT, DL, GL, GL-10, RX, XT, AND XT6 PASSENGER VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. CERTAIN SPX FILTRAN FUEL FILTERS WITH A 90-DEGREE ANGLE INLET TUBE, MODEL 800F300-S2, SOLD AS REPLACEMENT FILTERS FOR 19983-1994 SUBARU VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. FUEL MAY LEAK FROM THE FILTER DUE TO NON-CONFORMING BRAZING WELDS WHERE THE INLET TUBE IS CONNECTED TO THE FILTER CAN.

Número de llamada a revisión:

15V674000

Fecha de retirada:

2015-10-19

Componentes:

ELECTRICAL SYSTEM: IGNITION: SWITCH

Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.