MITSUBISHI Recall Check

Número de llamada a revisión:

88E023000

Fecha de retirada:

1988-09-23

Componentes:

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM: MANIFOLD/HEADER/MUFFLER/TAIL PIPE

HEAT SHIELD WAS INSTALLED ON LOWER SIDE OF MUFFLER INSTEAD OF THE UPPER SIDE.

Número de llamada a revisión:

95V103004

Fecha de retirada:

1995-05-24

Componentes:

SEAT BELTS: FRONT: BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Número de llamada a revisión:

95V103004

Fecha de retirada:

1995-05-24

Componentes:

SEAT BELTS: FRONT: BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Número de llamada a revisión:

95V103004

Fecha de retirada:

1995-05-24

Componentes:

SEAT BELTS: FRONT: BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Número de llamada a revisión:

95V103004

Fecha de retirada:

1995-05-24

Componentes:

SEAT BELTS: FRONT: BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Número de llamada a revisión:

95V103004

Fecha de retirada:

1995-05-24

Componentes:

SEAT BELTS: FRONT: BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Número de llamada a revisión:

88E023000

Fecha de retirada:

1988-09-23

Componentes:

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM: MANIFOLD/HEADER/MUFFLER/TAIL PIPE

HEAT SHIELD WAS INSTALLED ON LOWER SIDE OF MUFFLER INSTEAD OF THE UPPER SIDE.

Número de llamada a revisión:

84V098000

Fecha de retirada:

1984-09-11

Componentes:

ENGINE AND ENGINE COOLING: ENGINE

OIL PRESSURE GAUGE SENDING UNIT, LOCATED ON THE RIGHT HAND SIDE OF THE ENGINE, MAY LEAK OIL. ENGINE PARTS COULD BE DAMAGED DUE TO RESULTING LACK OF LUBRICATION.

Número de llamada a revisión:

82V109000

Fecha de retirada:

1982-11-18

Componentes:

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY: FILLER PIPE AND CAP

ON SOME OF THE INVOLVED VEHICLES, THE FUEL FILLER HOSE MAY BREAK IN A REAR-END COLLISION. THE FAILURE OF THE HOSE AND RESULTING FUEL LEAKAGE IS NOT IN COMPLIANCE WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".

Número de llamada a revisión:

83V057000

Fecha de retirada:

1983-06-01

Componentes:

VEHICLE SPEED CONTROL

SNAP PIN COULD INTERFERE WITH THE THROTTLE MECHANISM. IF THE ACCELERATOR PEDAL IS HEAVILY DEPRESSED, THE THROTTLE COULD BECOME STUCK IN THE OPEN POSITION. NORMALLY, WHEN ACCELERATOR PEDAL IS RELEASED, THROTTLE CLOSES AND VEHICLE SPEED DECREASES.