2002 NISSAN SENTRA Recall Check

Número de llamada a revisión:

02V056000

Fecha de retirada:

2002-02-27

Componentes:

UNKNOWN OR OTHER

ON SOME PASSENGER VEHICLES EQUIPPED WITH A NISSAN-APPROVED ACCESSORY FLOOR MAT THAT WAS INSTALLED EITHER AT THE ASSEMBLY PLANT OR BY THE DEALER, DUE TO THE LENGTH OF THE DRIVER SIDE FLOOR MAT, A SMALL AMOUNT OF MAT MOVEMENT COULD CAUSE THE MAT TO INTERFERE WITH THE ACCELERATOR PEDAL AND NOT ALLOW THE PEDAL TO RELEASE AFTER IT IS DEPRESSED.

Número de llamada a revisión:

01V376000

Fecha de retirada:

2001-12-20

Componentes:

EXTERIOR LIGHTING: HEADLIGHTS

VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE VEHICLES WERE MISSING TAMPERPROOF CAPS THAT PREVENT HORIZONTAL HEADLAMP ADJUSTMENT.

Número de llamada a revisión:

03V477000

Fecha de retirada:

2003-11-24

Componentes:

ELECTRICAL SYSTEM: IGNITION: MODULE

ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH THE QG18DE ENGINE OR QR25DE ENGINES, THE FOAM MATERIAL USED FOR THE INTERIOR LINING OF THE ELECTRONIC CONTROL MODULE (ECM) BOX EMITS SULFUR AS IT CURES.

Número de llamada a revisión:

03V455000

Fecha de retirada:

2003-11-19

Componentes:

ENGINE AND ENGINE COOLING

ON CERTAIN PASSENGER VEHICLES, THE CIRCUIT BOARD FOR THE CRANK POSITION SENSOR OR CAM POSITION SENSOR MAY HAVE AN IMPROPER SOLDER JOINT DUE TO SOLDER DEFORMATION CAUSED BY HEAT STRESS ACCELERATED BY THE EXISTENCE OF FLUX RESIDUE DURING THE SOLDERING PROCESS.

Número de llamada a revisión:

03V511000

Fecha de retirada:

2003-12-11

Componentes:

ENGINE AND ENGINE COOLING

ON CERTAIN ELECTRIC VEHICLES, THE FRONT SUSPENSION TRANSVERSE LINK'S BALL JOINT BRACKET MAY BREAK FROM STRESS CONCENTRATION AT A NOTCH CREATED BY SURFACE ROUGHNESS AND THE SHAPE OF THE MATERIAL CUT-LINE.

Número de llamada a revisión:

06E064000

Fecha de retirada:

2006-07-17

Componentes:

EXTERIOR LIGHTING

CERTAIN TRADESONIC COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Número de llamada a revisión:

06E023000

Fecha de retirada:

2006-03-14

Componentes:

EXTERIOR LIGHTING: HEADLIGHTS

CERTAIN ANZO COMBINATION HEADLAMP ASSEMBLIES SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES. SOME COMBINATION LAMPS ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Número de llamada a revisión:

03V084000

Fecha de retirada:

2003-03-18

Componentes:

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM: MANIFOLD/HEADER/MUFFLER/TAIL PIPE

ON CERTAIN VEHICLES EQUIPPED WITH THE 2.5 LITER ENGINE, THE EXHAUST PIPE HANGER PIN MAY CATCH DEBRIS FROM THE ROAD THAT COULD BE IGNITED BY CONTACT WITH THE MAIN CATALYST. ALSO ON 2002 ALTIMA AND SENTRA VEHICLES, CERTAIN ENGINE OPERATING CONDITIONS MAY CAUSE THE PRE-CATALYST TO OVERHEAT AND DAMAGE THE CATALYST SUBSTRATE.

Número de llamada a revisión:

09E025000

Fecha de retirada:

2009-05-11

Componentes:

EXTERIOR LIGHTING: HEADLIGHTS

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Número de llamada a revisión:

07V527000

Fecha de retirada:

2007-11-15

Componentes:

ENGINE AND ENGINE COOLING

ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.