2002 CHEVROLET MALIBU Recall Check

Akcja serwisowa nr:

02V107000

Data wycofania:

2002-04-15

Podzespoły:

EXTERIOR LIGHTING: HEADLIGHTS

CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." SOME OF THESE VEHICLES WERE PRODUCED WITH A LEFT LOW-BEAM HEADLAMP THAT DOES NOT MEET THE PHOTOMETRIC PERFORMANCE REQUIREMENTS OF THE STANDARD.

Akcja serwisowa nr:

07E021000

Data wycofania:

2007-03-12

Podzespoły:

FUEL SYSTEM, OTHER: STORAGE: TANK ASSEMBLY: PRESSURE RELIEF DEVICES

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

Akcja serwisowa nr:

09E012000

Data wycofania:

2009-04-07

Podzespoły:

EXTERIOR LIGHTING

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Akcja serwisowa nr:

14V400000

Data wycofania:

2014-07-07

Podzespoły:

ELECTRICAL SYSTEM: IGNITION

This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 3, 2014, that they are recalling 5,877,718 model year 2000-2005 Chevrolet Impala and Monte Carlo, 1997-2003 Chevrolet Malibu, 2004-2005 Malibu Classic, 1999-2004 Oldsmobile Alero, 1998-2002 Oldsmobile Intrigue, 1999-2005 Pontiac Grand Am and 2004-2008 Pontiac Grand Prix vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine.