Где найти VIN?
•
Нет VIN?
Купите пакет отчётов EpicVIN
THE INVOLVED VEHICLES MAY HAVE BEEN PRODUCED WITH REAR AXLE SHAFTS (RIGHT OR LEFT) THAT DID NOT RECEIVE PROPER HEAT TREATMENT OF THE BEARING JOURNALS.
THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT THE MIDSHIP FUEL TANK PROTECTIVE SHIELDS. AS A RESULT, THEY DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", DUE TO EXCESSIVE FUEL SPILLAGE UPON FRONTAL IMPACT.
THE OPTIONAL TANDEM SUSPENSION ASSEMBLY MAY HAVE BEEN INSTALLED USING A STANDARD BEAM END ADAPTER KIT, RATHER THAN THE REQUIRED SPECIAL KIT. PROGRESSIVE DETERIORATION COULD OCCUR TO THE ADAPTER TO BEAM END BUSHING JOINT, POSSIBLY RESULTING IN FRACTURE OF THE BEAM TO AXLE ATTACHING BOLTS.
THE INVOLVED VEHICLES MAY HAVE BEEN PRODUCED WITH REAR AXLE SHAFTS (RIGHT OR LEFT) THAT DID NOT RECEIVE PROPER HEAT TREATMENT OF THE BEARING JOURNALS.
THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT THE MIDSHIP FUEL TANK PROTECTIVE SHIELDS. AS A RESULT, THEY DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", DUE TO EXCESSIVE FUEL SPILLAGE UPON FRONTAL IMPACT.
THE OPTIONAL TANDEM SUSPENSION ASSEMBLY MAY HAVE BEEN INSTALLED USING A STANDARD BEAM END ADAPTER KIT, RATHER THAN THE REQUIRED SPECIAL KIT. PROGRESSIVE DETERIORATION COULD OCCUR TO THE ADAPTER TO BEAM END BUSHING JOINT, POSSIBLY RESULTING IN FRACTURE OF THE BEAM TO AXLE ATTACHING BOLTS.
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
WITH THE ENGINE OPERATING AT HIGH SPEED, THE PLASTIC ENGINE FAN FINGER GUARDS MAY CONTACT THE ENGINE FAN AND BREAKAGE OF THE GUARD MAY OCCUR. THIS COULD CAUSE FRAGMENTS OF THE FINGER GUARD TO SCATTER.
THE TILT STEERING COLUMNS ON THE INVOLVED VEHICLES CONTAIN IN-PROCESS TEMPORARY ALIGNMENT PINS RATHER THAN THE PERMANENT PRESS-FIT PIVOT PINS. THE TEMPORARY PINS ARE SLIGHTLY UNDERSIZED AND COULD SEPARATE FROM THE STEERING COLUMN DURING VEHICLE OPERATION. THIS CAN CAUSE STEERING WHEEL LOCKUP.
Ознакомьтесь с советами экспертов, новостями и консультациями по покупке и техническому обслуживанию подержанных автомобилей
Прочтите эту статью, чтобы узнать, как защитить машину от грызунов
Подробнее
Наша команда расскажет Вам, что такое тайтл автомобиля.
Подробнее
Прочтите эту статью, и узнаете много полезной информации о VIN вашего автомоби...
Подробнее
