¿Dónde el VIN?
•
Sin VIN?
Obtenga reportes de EpicVIN
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
VEHICLE DESCRIPTION: SCHOOL BUSES, MEDIUM DUTY TRUCKS AND TRACTORS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
CERTAIN FEDERAL-MOGUL REPLACEMENT WHEEL HUB ASSEMBLIES WITH THE BRAND NAMES: NATIONAL, CARQUEST P/NOS. 515020, 515021, 515025, 515053, 515054, 515059, AND 515060, SHIPPED BETWEEN JANUARY 23, 2006, AND DECEMBER 20, 2007, SOLD FOR LIGHT DUTY AND MEDIUM DUTY TRUCKS. THE INBOARD RETENTION NUT USED TO MAINTAIN HUB BEARING ASSEMBLY CAN LOOSEN RESULTING IN AN ABS LIGHT INDICATION, NOISE, AND/OR WHEEL SEPARATION.
VEHICLE DESCRIPTION: SCHOOL BUSES, MEDIUM DUTY TRUCKS AND TRACTORS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
CERTAIN MEDIUM DUTY TILT CAB TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS HAVE A CONDITION IN WHICH THE CLUTCH MASTER-CYLINDER PUSHROD END THAT ATTACHES TO THE CLUTCH PEDAL PIN CAN WEAR PREMATURELY. THE FIRST NOTICEABLE EFFECT OF THIS WEAR COULD BE THE CLUTCH PEDAL NOT RETURNING COMPLETELY TO THE FULL-UP POSITION.
CERTAIN FEDERAL-MOGUL REPLACEMENT WHEEL HUB ASSEMBLIES WITH THE BRAND NAMES: NATIONAL, CARQUEST P/NOS. 515020, 515021, 515025, 515053, 515054, 515059, AND 515060, SHIPPED BETWEEN JANUARY 23, 2006, AND DECEMBER 20, 2007, SOLD FOR LIGHT DUTY AND MEDIUM DUTY TRUCKS. THE INBOARD RETENTION NUT USED TO MAINTAIN HUB BEARING ASSEMBLY CAN LOOSEN RESULTING IN AN ABS LIGHT INDICATION, NOISE, AND/OR WHEEL SEPARATION.
VEHICLE DESCRIPTION: MINI VANS WITH EXTENDED WHEELBASE. SOME OF THESE VEHICLES HAVE INOPERATIVE FUEL TANK ROLLOVER VALVES AND FUEL LEAKAGE WOULD EXCEED THE PERMISSIBLE AMOUNT IN A ROLLOVER TEST. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 301, "FUEL SYSTEM INTEGRITY."
VEHICLE DESCRIPTION: CHASSIS CABS. THE TAPERED HOLE IN THE DRAG LINK END THAT ATTACHES TO THE PITMAN ARM TAPERED BALL STUD MAY BE MACHINED TOO DEEP CAUSING THE HOLE TO BE OVERSIZED. A DRAG LINK WITH AN OVERSIZED HOLE MAY NOT "SEAT" THE PITMAN ARM TAPERED BALL WHEN ASSEMBLED. THIS COULD CAUSE HIGHER THAN NORMAL FRICTION BETWEEN COMPONENTS DURING OPERATION, AND POSSIBLY RESULT IN JOINT SEPARATION OR A BROKEN BALL STUD.
RIDE CONTROL IS RECALLING CERTAIN FRONT STRUT MOUNTS BRANDED AS GABRIEL RIDE CONTROL OR ARVINMERITOR, P/NOS. 142435, 142193, 142305, 142303, SOLD AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE AFFECTED FRONT STRUT MOUNTS DID NOT CONTAIN A WELD JOINT BETWEEN THE BEARING HOUSING AND THE RATE PLATE.
Descubra consejos de expertos, sugerencias y noticias sobre la compra y el mantenimiento de vehículos usados.
Lea este artículo para descubrir mucha información sobre el motor del automóvi...
Lea mas
Una guía sobre las mejores formas de vender un auto en 2023.
Lea mas
Nuestro equipo le dirá cómo leer los números de VIN de Porsche
Lea mas
