¿Dónde el VIN?
•
Sin VIN?
Obtenga reportes de EpicVIN
REAR SEAT BELT RETRACTORS MAY ALLOW TWISTED WEBBING TO ENTER THE RETRACTOR HOUSING AND JAM THE RETRACTOR. CONSEQUENCE OF DEFECT: A JAMMED RETRACTOR WOULD INTERFERE WITH WEBBING RETRACTION AND WITHDRAWAL. THIS WILL DISCOURAGE SEAT BELT USAGE.
SEAT FRAME STRUCTURE COULD SEVER FRONT SEAT BELTS IF VEHICLE IS INVOLVED IN AN ACCIDENT, DEPENDING ON FORCE OF IMPACT.
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.
INADEQUATE LUBRICATION OF THE STEERING SHAFT COULD CAUSE STEERING SHAFT ASSEMBLIES TO SEPARATE WITHOUT WARNING.
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.
ON THE INVOLVED VEHICLES, A THERMAL LIMITER IN THE BLOWER MOTOR RESISTOR CIRCUIT OF THE AIR CONDITIONER/HEATER ASSEMBLY MAY NOT FUNCTION AS INTENDED. IF THE BLOWER MOTOR BECOMES JAMMED WHEN THE SYSTEM IS OPERATING IN THE MEDIUM-LOW BLOWER SPEED, THE RESISTOR COILS CAN OVERHEAT CAUSING MELTING AND POSSIBLE IGNITION.
SOME OF THE SUSPECT VEHICLES MAY HAVE BEEN PRODUCED WITH THE POSITIVE BATTERY CABLE INCORRECTLY INDEXED AT THE ATTACHMENT TO THE STARTER SOLENOID. CABLE INSULATION DAMAGE COULD OCCUR DUE TO METAL ON METAL CONTACT DURING MAXIMUM ENGINE ROLL CONDITIONS. AN ELECTRICAL SHORT MAY DEVELOP BETWEEN THE BATTERY CABLE AND A BRAKE TUBE. A HOLE COULD BE FORMED IN THE BRAKE TUBE, RESULTING IN LOSS OF BRAKE FLUID AND REDUCED BRAKING CAPABILITY.
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.
Descubra consejos de expertos, sugerencias y noticias sobre la compra y el mantenimiento de vehículos usados.
Nuestro equipo le dirá qué hacer si su VIN es incorrecto.
Lea mas
Hoy analizaremos qué es un número de bastidor, por qué es vital y cómo influye...
Lea mas
Ahorre mucho dinero en el seguro de automóvil siguiendo los pasos sugeridos en...
Lea mas
