CHEVROLET Recall Check

N° de rappel :

07E088000

Date du rappel :

2007-10-30

Composant(s) :

EQUIPMENT

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

N° de rappel :

07E088000

Date du rappel :

2007-10-30

Composant(s) :

EQUIPMENT

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

N° de rappel :

79V195000

Date du rappel :

1979-12-11

Composant(s) :

VEHICLE SPEED CONTROL: LINKAGES

SOME OF THE INVOLVED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS". THE ACCELERATOR CROSS SHAFT SUPPORT BRACKET WAS IMPROPERLY INSTALLED IN A REVERSED END FOR END POSITION IN THESE CASES. THIS COULD CAUSE A SLIGHT BEND IN THE ACCELERATOR LINKAGE, RESULTING IN A DELAY IN THE RETURN OF THE THROTTLE TO THE IDLE POSITION.

N° de rappel :

77V163000

Date du rappel :

1979-10-12

Composant(s) :

SUSPENSION: REAR

THE REAR AXLE SHAFTS ON THE INVOLVED VEHICLES MAY HAVE A FLAW IN THE METAL. AS A RESULT, THE SHAFT MAY BREAK, WHICH WOULD ALLOW THE TIRE AND WHEEL ASSEMBLY TO SEPARATE FROM THE VEHICLE.

N° de rappel :

77V111000

Date du rappel :

1979-10-12

Composant(s) :

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: MASTER CYLINDER

ON THE INVOLVED VEHICLES, THE BRAKE MASTER CYLINDER MAY HAVE BEEN ASSEMBLED WITH RESERVOIR MOUNTING BOLTS THAT WERE IMPROPERLY PROCESSED. THIS COULD MAKE THESE BOLTS BRITTLE AND SUBJECT TO BREAKING. IF BREAKAGE OCCURS, A BRAKE FLUID LEAK MAY DEVELOP BETWEEN THE RESERVOIR AND MASTER CYLINDER. LOSS OF BRAKE FLUID WOULD ADVERSELY AFFECT VEHICLE BRAKING CAPABILITY.

N° de rappel :

77V111000

Date du rappel :

1979-10-12

Composant(s) :

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: MASTER CYLINDER

ON THE INVOLVED VEHICLES, THE BRAKE MASTER CYLINDER MAY HAVE BEEN ASSEMBLED WITH RESERVOIR MOUNTING BOLTS THAT WERE IMPROPERLY PROCESSED. THIS COULD MAKE THESE BOLTS BRITTLE AND SUBJECT TO BREAKING. IF BREAKAGE OCCURS, A BRAKE FLUID LEAK MAY DEVELOP BETWEEN THE RESERVOIR AND MASTER CYLINDER. LOSS OF BRAKE FLUID WOULD ADVERSELY AFFECT VEHICLE BRAKING CAPABILITY.

N° de rappel :

79V195000

Date du rappel :

1979-12-11

Composant(s) :

VEHICLE SPEED CONTROL: LINKAGES

SOME OF THE INVOLVED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS". THE ACCELERATOR CROSS SHAFT SUPPORT BRACKET WAS IMPROPERLY INSTALLED IN A REVERSED END FOR END POSITION IN THESE CASES. THIS COULD CAUSE A SLIGHT BEND IN THE ACCELERATOR LINKAGE, RESULTING IN A DELAY IN THE RETURN OF THE THROTTLE TO THE IDLE POSITION.

N° de rappel :

77V163000

Date du rappel :

1979-10-12

Composant(s) :

SUSPENSION: REAR

THE REAR AXLE SHAFTS ON THE INVOLVED VEHICLES MAY HAVE A FLAW IN THE METAL. AS A RESULT, THE SHAFT MAY BREAK, WHICH WOULD ALLOW THE TIRE AND WHEEL ASSEMBLY TO SEPARATE FROM THE VEHICLE.

N° de rappel :

77V115000

Date du rappel :

1979-10-12

Composant(s) :

ELECTRICAL SYSTEM: HORN

THE INVOLVED VEHICLES HAVE STEERING WHEEL CENTER HUBS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 107, "REFLECTING SURFACES". THE HORN BUTTON CAP AND THE LOCK LEVER HAVE A BRUSHED CHROME FINISH. THE SURFACE REFLECTIVITY OF THIS FINISH ON SOME OF THESE HORN BUTTON CAPS AND LOCK LEVERS IS APPROXIMATELY TWICE THE MAXIMUM REFLECTIVITY ALLOWED BY THE STANDARD.

N° de rappel :

77V163000

Date du rappel :

1979-10-12

Composant(s) :

SUSPENSION: REAR

THE REAR AXLE SHAFTS ON THE INVOLVED VEHICLES MAY HAVE A FLAW IN THE METAL. AS A RESULT, THE SHAFT MAY BREAK, WHICH WOULD ALLOW THE TIRE AND WHEEL ASSEMBLY TO SEPARATE FROM THE VEHICLE.