DODGE MONACO Recall Check

Número de llamada a revisión:

90V058000

Fecha de retirada:

1990-03-30

Componentes:

STEERING: STEERING WHEEL/HANDLE BAR

LOWER INTERMEDIATE STEERING SHAFT MAY SEPARATE AT THE RUBBER ISOLATED COUPLING OF THE SHAFT.

Número de llamada a revisión:

94V006000

Fecha de retirada:

1994-01-14

Componentes:

VISIBILITY: DEFROSTER/DEFOGGER/HVAC SYSTEM: HEATER CORE

THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE INTO THE PASSENGER COMPARTMENT.

Número de llamada a revisión:

91V027000

Fecha de retirada:

1991-02-25

Componentes:

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: HOSES, LINES/PIPING, AND FITTINGS

REAR BRAKE TUBE ROUTING IS CONTACTED BY FUEL TANK HEAT SHIELD WHEN SUSPENSION IS IN FULL JOUNCE POSITION. THIS DAMAGES THE BRAKE FLUID TUBE, CAUSING A LEAK.

Número de llamada a revisión:

90V205000

Fecha de retirada:

1990-12-28

Componentes:

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: HOSES, LINES/PIPING, AND FITTINGS

ROUTING OF THE FRONT BRAKE HOSE MAY CAUSE EXCESSIVE HOSE FLEXING RESULTING IN PREMATURE FATIGUE CRACKING OF THE OUTER HOSE COVER.

Número de llamada a revisión:

98V005000

Fecha de retirada:

1998-01-22

Componentes:

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: DISC: ROTOR

VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.

Número de llamada a revisión:

95V213000

Fecha de retirada:

1995-11-09

Componentes:

SEAT BELTS: FRONT: ANCHORAGE

THE AUTOMATIC SHOULDER BELT SYSTEMS CAN MALFUNCTION AND BECOME INOPERATIVE.

Número de llamada a revisión:

77V211000

Fecha de retirada:

1979-10-12

Componentes:

STEERING: STEERING WHEEL/HANDLE BAR

THE COLUMNS MAY CONTAIN STEERING SHAFTS IN WHICH THE STEERING COLUMN COUPLING ROLL PIN RETAINING NOTCH WAS MACHINED TOO DEEP. THIS MAY CAUSE THE STEERING WHEEL SHAFT TO BECOME DISENGAGED FROM THE REST OF THE STEERING ASSEMBLY.

Número de llamada a revisión:

78V020000

Fecha de retirada:

1979-10-12

Componentes:

FUEL SYSTEM, GASOLINE: CARBURETOR SYSTEM

WHEN THE ACCELERATOR PEDAL ON THE INVOLVED VEHICLES IS DEPRESSED AND THE ACCELERATOR PUMP IS ACTIVATED, A DISTORTED ACCELERATOR PUMP SEAL IN THE CARBURETOR MAY PREVENT THE PUMP FROM DELIVERING THE PROPER AMOUNT OF FUEL.

Número de llamada a revisión:

77V131000

Fecha de retirada:

1979-10-12

Componentes:

POWER TRAIN: AUTOMATIC TRANSMISSION

THE PLASTIC TRANSMISSION SHIFT LINKAGE BUSHINGS INSTALLED ON THE INVOLVED VEHICLES MAY BECOME HEAT DAMAGED BECAUSE THEY ARE LOCATED NEAR THE MINI-CATALYTIC CONVERTER. THIS CONDITION COULD ALTER THE ADJUSTED RELATIONSHIP OF THE TRANSMISSION SHIFT LINKAGE, CAUSING THE TRANSMISSION TO BE IN A GEAR POSITION OTHER THAN THAT INDICATED BY THE GEAR SHIFT SELECTOR.

Número de llamada a revisión:

77V037000

Fecha de retirada:

1979-10-12

Componentes:

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM: MANIFOLD/HEADER/MUFFLER/TAIL PIPE

THE REQUIRED MUFFLER TO FLOOR PAN HEAT SHIELDS WERE OMITTED FROM THE INVOLVED VEHICLES. THESE HEAT SHIELDS ARE NECESSARY TO PROTECT THE PASSENGER COMPARTMENT INTERIOR MATERIALS, INCLUDING SEAT BELT WEBBING, FROM HEAT DAMAGE.