MITSUBISHI PRECIS Recall Check

N° de rappel :

95V059000

Date du rappel :

1995-03-31

Composant(s) :

VISIBILITY: DEFROSTER/DEFOGGER/HVAC SYSTEM: HEATER CORE

VEHICLES INVOLVED ARE THOSE THAT HAD THE HEATER VALVE STEMS REPLACED IN AN EARLIER MITSUBISHI RECALL (94V-103.001). CERTAIN VEHICLES HAD AN INCORRECT VALVE STEM INSTALLED WHICH COULD CAUSE THE INCORRECT STEM TO LEAK AFTER A PERIOD OF TIME.

N° de rappel :

91V225000

Date du rappel :

1992-01-06

Composant(s) :

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM

DETERIORATION OF THE REED VALVE SUBASSEMBLY MAY LEAD TO A MALFUNCTION WITHIN THE SECONDARY AIR SUPPLY PORTION OF THE EMISSION CONTROL SYSTEM. THE SCREWS WHICH ATTACH THE REEDS TO THE REED VALVE SUBASSEMBLY MAY RUST, AND IF THE RUSTING BECOMES SEVERE, THE SCREW HEADS WILL ERODE AND ALLOW THE REEDS TO SEPARATE FROM THE REED VALVE SUBASSEMBLY. CORROSION MAY ALSO OCCUR ON THE REED VALVE SUBASSEMBLY, DEFORMING THE REED SEATS AND PREVENTING THE REEDS FROM CLOSING PROPERLY. SEPARATION OF THE REEDS FROM THE REED VALVE SUBASSEMBLY OR IMPROPER CLOSING OF THE REEDS ALLOW HOT EXHAUST GASES TO FLOW BACKWARD INTO THE PLASTIC SECONDARY AIR FILTER CASE WHEN THE VEHICLE IS BEING DRIVEN. THESE HOT EXHAUST GASES MAY MELT THE SECONDARY PLASTIC AIR FILTER CASE.

N° de rappel :

87V180000

Date du rappel :

1987-12-04

Composant(s) :

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: DISC: PADS

VEHICLE MAY FAIL TO CONFORM TO THE BRAKE FADE AND RECOVERY PORTION OF FMVSS 105.

N° de rappel :

91V225000

Date du rappel :

1992-01-06

Composant(s) :

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM

DETERIORATION OF THE REED VALVE SUBASSEMBLY MAY LEAD TO A MALFUNCTION WITHIN THE SECONDARY AIR SUPPLY PORTION OF THE EMISSION CONTROL SYSTEM. THE SCREWS WHICH ATTACH THE REEDS TO THE REED VALVE SUBASSEMBLY MAY RUST, AND IF THE RUSTING BECOMES SEVERE, THE SCREW HEADS WILL ERODE AND ALLOW THE REEDS TO SEPARATE FROM THE REED VALVE SUBASSEMBLY. CORROSION MAY ALSO OCCUR ON THE REED VALVE SUBASSEMBLY, DEFORMING THE REED SEATS AND PREVENTING THE REEDS FROM CLOSING PROPERLY. SEPARATION OF THE REEDS FROM THE REED VALVE SUBASSEMBLY OR IMPROPER CLOSING OF THE REEDS ALLOW HOT EXHAUST GASES TO FLOW BACKWARD INTO THE PLASTIC SECONDARY AIR FILTER CASE WHEN THE VEHICLE IS BEING DRIVEN. THESE HOT EXHAUST GASES MAY MELT THE SECONDARY PLASTIC AIR FILTER CASE.