Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
Can you please guide me through the steps for resetting the oil light on a 2010 Dodge Ram 2500?
5871 views
2 answers
★ Top Answer
Resetting the oil light on a 2010 Dodge Ram2500 is a simple task that can be completed in about 6 to 12 minutes. Begin by going to the driver's side of your vehicle and entering. Ensure that the engine is not running. Turn the ignition to the on or run position, being careful not to start the engine accidentally. Press the gas pedal three times slowly within a 10-second timeframe. Then, turn the ignition off and start the engine.
More answers
-
To clear the oil light on a 2010 Dodge Ram 2500, you can do the following steps: First, switch on the ignition without starting the engine. Next, press the accelerator pedal down three times within 10 seconds. Finally, turn off the ignition. Keep in mind that if the message is still showing when you start the engine, the reset hasn't been successful. Just repeat the process to try again.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
