Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
2170 views
9 answers
The location of the camshaft position sensor in a 2002 Dodge Ram 1500 5.9 varies among different models, but it is always positioned near the crankshaft. If you need to replace the sensor, it could set you back between $190 and $300, with an additional $200 for installation labor. This sensor plays a crucial role in ensuring the crankshaft operates at the right speed. Signs of a malfunctioning sensor include stalling, shaking, rough acceleration, and the illumination of the check engine light. These issues arise because the engine's timing is off, resulting in poor firing. Not only does this pose immediate problems, but it also strains the engine, potentially leading to further damage and expenses over time.
You're clueless and way off base.
Check under the generator to locate the camshaft position sensor in the 2002 Dodge Ram 1500.
in a 2002 Dodge Ram 1500 5.9, you can locate the camshaft position sensor underneath the generator on the timing chain/case cover on the right front side of the engine.
Remove the distributor cap and the rotor assembly. You will see a flat disc with wires attached to it. In the 2002 Dodge Ram 1500 5.9L Magnum, this component is referred to as the pick-up coil.
It has been suggested by some that the key lies within the distributor.
There are two correct answers depending on whether you have the older 5.9 block from 1994 to 2002 or the newer block from 2002 onwards. The location of the crank sensor also varies. In my case, I have the block from 1994 to 2002, where the sensor is in the distributor rather than by the timing chain cover.
The camshaft sensor for a 2002 Dodge 1500 with a 5.9L engine is situated inside the distributor. It is a flat, circular component that includes an electrical connection exiting from the distributor.
There's a lot of false info online. That's the internet for you. The cam position sensor for a 2002 5.9L is found in the distributor. It costs around $30. The most challenging aspect is separating the old connector without damaging it.