Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I clear the abs warning light on my Honda Accord?
5771 views
4 answers
★ Top Answer
To reset the anti-lock brake light on the Honda Accord, you should follow these steps. First, turn the key to the on position without starting the engine. Wait for the SRS light to come on, which will last for two to three seconds. Once it goes off, turn the ignition off, then back on and wait for the light to come on again. Turn the ignition off once the light appears. By doing this, you will short the connection and turn off the light. Please be aware that this method is not ideal for the car, so it is advised not to attempt it.
More answers
-
Make sure to check your brake fluid level. If the light is still on, try disconnecting the positive terminal for a minute or so to reset it.
-
Install new brakes and rotate tires, and also install a speed sensor.
-
Turn the ignition key to the "on" position (without starting the engine) to reset the airbag light sensor in a Honda Accord equipped with this connection. The SRS light will illuminate for two seconds and then turn off. Once the light is off, the shorting wire is disconnected to restore the circuit to its original state. The SRS light will then come back on. Please be aware that resetting the airbag sensor is not recommended and could potentially lead to harm.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
