Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I do a reset on the tire pressure sensor of my 2014 Chevrolet Impala?
4303 views
2 answers
★ Top Answer
To start, ensure that the 2014 Chevrolet Impala is parked on a level surface. Verify the tire pressure in each tire and ensure it matches the correct psi indicated on the tire's side. Once this is done, enter the car and switch on the power without starting the engine. Locate the button to the right of the steering wheel labeled as tpms or similar. Press and hold it until it starts blinking. Leave the car untouched for approximately 20 minutes to allow for recalibration. After the blinking stops, you can turn off the car and then restart it to confirm that the reset was successful.
More answers
-
To reinitialize the tpms on the 2014 Chevy Impala, ensure the tire pressure is accurate, start the car, and press the reset button located on the right side of the steering wheel. Wait for ten minutes, and if necessary, keep the button pressed until the light flashes. If the sensor malfunctions, it could indicate improper tire pressure, affecting the vehicle's performance negatively.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
