Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I reboot the Chevy Malibu's computer system?
29655 views
7 answers
★ Top Answer
When owning a Chevy Malibu, you have two ways to reset the computer. Firstly, you can unplug and then plug back in the battery. The second option is resetting the fuse found in the engine control module. To replace the battery, simply disconnect it, wait around twenty minutes, and reconnect it. If this doesn't reboot the computer, you'll need to find the fuse box and reset the fuse. Consult your owner's manual for guidance on locating the fuse box and how to reset the fuse. It should provide detailed instructions on resetting the computer and replacing the PCM if needed.
More answers
-
Disconnect the red cable from the battery using needle-nose pliers. Then, locate the fuse box and refer to the diagram. Identify the fuse marked "ecm" and carefully remove it.
-
When you change the engine, do you have to reset the module so it can recognize the new motor you installed?
-
I'm keeping my fingers crossed that it turns out as expected.
-
Janice R discovered that an 8 mm box wrench is more effective for the task as opposed to using needle nose pliers, which could potentially harm the cable connector.
-
Always keep the positive in place, and remember to take out the negative when replacing parts. Cheers!
-
Do I have to reset my 2013 Chevy Malibu if I install a new ignition system and key?
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
