Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I reset the anti-theft system on a 2006 Chevrolet Impala?
5796 views
9 answers
★ Top Answer
To reset the alarm on a 2006 Chevy Impala, you have two choices. The first option is to open the hood and disconnect the positive battery cable, keeping it off for approximately 30 minutes. This will help drain the power from the CPU, prompting the system to reset when powered back on. The alternative option is to remove the fuse from the fuse box and wait for a similar amount of time. While both methods achieve the same result, pulling the battery will reset numerous systems, whereas pulling the fuse will only reset the alarm. However, you will need to refer to the fuse diagram to identify the correct fuse to remove.
More answers
-
To disable the anti-theft system in a 2006 Chevy Impala, turn the vehicle on without starting the engine and wait for 10 minutes.
-
This issue is persisting... there has been no change despite trying both solutions... I'm in need of assistance!
-
To reset the system, simply turn the key to the on position and wait for the security light to go out, then turn the key off for ten seconds. You may need to repeat this process three or four times, but it is guaranteed to work.
-
I just put in a new steering column and now it's in anti-theft or security mode.
-
I tried using both of them, but it was unsuccessful.
-
I've attempted multiple times, but nothing seems to resolve the issue. What steps must be taken to find a permanent solution to fix it?
-
I installed a new anti-theft device, and now the car won't start. All systems are functional, but there is no response from the engine when trying to start it.
-
It will only cease to function if you are unable to power it on again using the analog input.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
