Vehicle Questions and Answers

Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!

How can I reset the Dodge DEF system?

13432 views

6 answers

★ Top Answer
Ibrahim

To reinitialize the Dodge DEF system, you will need to reset the computer itself. Since there is no official method for this, you'll have to think outside the box. To begin, pop the hood of the truck and secure it. Locate the battery in the hood and identify the negative cable while leaving the positive one untouched. Remove the negative cable, then wait for approximately 30 minutes to an hour. Reattach the cable, start the truck, and you should notice that all lights and systems have been reset, including the DEF. This is because once the computer loses its charge, it loses its memory and resets everything automatically.

More answers

  • Gurinder Chandi

    I've attempted all of the suggested solutions on the vehicle, but it still shows 8 miles to go until reaching 5 mph. It's strange that it worked initially, then reappeared and won't reset now.

  • Amanda T

    I just gave it a shot, but nothing happened. I removed both batteries and waited for more than an hour, but nothing changed. I'm driving a brand-new 2022 Ram 3500.

  • Numbers F.

    I recently replaced the sensor in my DEF tank with a high-quality one that is attached inside the tank. The dealership quoted me over $3,000 to fix the issue, but I purchased the tank from Mopar for $1,900. However, I am unable to get rid of the engine malfunction light or the "see dealer" message related to DEF.

  • Martilia chery

    While returning from a hunting trip in the mountains on a Sunday with my camper being towed by my Jeep, I encountered a situation where my vehicle was about to go into limp mode. Instead of waiting for that to happen, I pulled over after receiving a warning that it would occur in 150 miles. I proceeded to clean the injector nozzle and disconnected the negative cables while I worked on it. The nozzle was simple to remove and clean. I then drove the remaining 240 miles home without any problems. Now that I am back home, I plan to investigate the pump as well.

  • Jakecarl

    My 2017 2500 truck is experiencing the same issue, and I'm stranded far away from any help. Will it enter limp mode if I continue driving it?

Buying a Used car?
Check it by Epicvin
  • Safe checkout guaranteed
  • Niada logo
  • Blockchain confirmed data