Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I reset the ECU on a 2007 Toyota RAV4?
2903 views
2 answers
★ Top Answer
To reset the ECU on a 2007 Toyota RAV4, follow these easy steps that will only take a few minutes of your time. Begin by entering the driver's side of your car and inserting the key into the ignition, turning it to the on position without starting the engine. Press the gas pedal all the way down with your right foot for about 3 seconds before releasing it. Turn the ignition off, then start the engine. By doing this, you should successfully reset the ECU.
More answers
-
To reset the ECU on a 2007 Toyota RAV4, follow these steps: 1. Make sure the accelerator pedal is not pressed, then turn on the ignition switch and wait for 3 seconds. 2. Repeat the following actions (2a and 2b) five times within 5 seconds. 2A. Press the accelerator pedal down completely. 2B. Release the accelerator pedal fully. 3. Wait for 7 seconds, then press the accelerator pedal until it blinks. 4. Release the accelerator pedal while it's still blinking. 5. Press and hold down the accelerator pedal fully. 6. Release the accelerator pedal completely. 7. Turn the ignition switch to the "off" position, and your car is ready to start.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
