How can I reset the tire pressure monitoring system on a 2019 Ford Fiesta?

4092 views

3 answers

★ Top Answer

Nadia P. Jan 26, 2021

To reset the TPMS on a 2019 Ford Fiesta, start by ensuring that each tire is inflated to 32 psi. Then, step on the brake pedal for 3 seconds and let go. Turn the ignition on and off three times, leaving it on the third time. Step on the brake pedal again for 3 seconds and release. Turn the ignition off by pressing the start button. Next, cycle the ignition on and off three times, leaving it on the third time. You'll hear the horn honk once and see the message "train left front tire" on the display. This indicates that the system is recalibrating the tire sensors. Once the process is complete, turn off the ignition by pressing the start button. If successful, the horn will honk twice. If not, simply repeat the entire procedure.

More answers

Marquis May 14, 2020

To reset the tire pressure monitoring system in a 2019 Ford Fiesta, start by pressing the menu button on the dashboard. Navigate to the vehicle settings using the down arrow and confirm by pressing ok. Locate the tire monitoring option and select ok. Hold down the ok button for a moment until you receive a confirmation message about the tire pressure being reset. Finally, release the ok button.
Brian Veal Dec 4, 2021

I verified that the following steps are applicable to the 2019 Ford Fiesta ST: Please note that with some models, you may need to press the start button twice (without touching the brake) to switch to RUN mode (Ignition ON/Engine OFF). If this is the case, make adjustments to steps 3 and 5 as directed. Engage the parking brake and make sure all tires are properly inflated. With the vehicle turned off, press and release the brake pedal. Next, press the START button five times (or eight times if double press required for RUN). Then, press and release the brake pedal again. Proceed to press the START button six times (or nine times if double press required for RUN). A single horn honk will signal that the relearn mode is active. Utilize the tool to trigger the left front sensor, indicated by another single horn sound. Proceed to repeat this process for the right front, right rear, and left rear tires. Once all sensors have been learned, the message center will display "TRAINING MODE COMPLETE.

Buying a Used car?
Check it by Epicvin