Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I reset the tire pressure sensor on a 2019 Ram 1500?
14440 views
8 answers
★ Top Answer
To reset the tire pressure sensor in a 2019 Dodge Ram 1500 is a simple task that can be completed within 4 to 5 minutes. Begin by going to the driver's side of your vehicle and entering. Turn the ignition to the on position without starting the engine. Find the TPMS button and press it down until the light flashes three times. Release the button, start the engine, and let it run for 20 to 30 minutes for the sensor to reset.
More answers
-
Where can I find the TPMS reset button on my 2019 Ram 1500 Laramie? I've checked beneath the steering column but can't seem to locate it.
-
Is there a reset button on the 2019 Dodge Classic? I can't find any buttons below my steering wheel.
-
To recalibrate the tire pressure monitoring system (TPMS) on a 2019 Ram 1500, begin by turning on the ignition and then pressing and holding the reset button for the TPMS before starting the vehicle. Release the button when the tire pressure light flashes three times. After that, start the engine and allow it to run for approximately 20 minutes. This process should reset the sensor. Then, drive for at least 10 minutes at a speed of 50 mph or higher, preferably on the highway for optimal results.
-
Disconnect the battery for 5 minutes and then reattach it to reset the map settings, etc.
-
There is no switch present on the truck.
-
I want to switch the wheels and tires from the Lone Star to the Limited trim. Do I need to replace the sensors as well?
-
It should automatically reset once the tires are inflated to the recommended pressure. If they are even slightly underinflated, it won't reset.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
