Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
968 views
2 answers
The bumper on your Toyota Corolla is attached at the top, bottom, and sides. You should find 10 fasteners holding the bumper cover in place within each fender well. To start, remove these fasteners and the fender well liner. Use a small screwdriver to pop up the center button on the plastic fasteners without fully removing them. Remove the engine splash panels below the bumper cover to access the lower fasteners, then remove the screws and plastic pins. The screws that secure the grille also hold the top of the bumper cover in place. Unscrew the side screws of the grille and take it off. Make sure all fasteners are removed before lifting and pulling off the bumper cover, which may require at least two people.
In order to take off the front bumper, you will require a screwdriver and a socket/wrench set. Unscrew the ten screws and fasteners that hold the bumper cover in place. Move aside the inner fender liner in the wheel well to reach the clips and screws hidden behind. Begin at the corners and carefully pull off the cover from the car.