Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How do I reset the airbag light on my 2005 Honda Pilot?
2221 views
2 answers
★ Top Answer
To reset the airbag light in the 2005 Honda Pilot, start by finding the fuse box located by the driver's left foot on the sidewall. Locate the specific yellow connector and disconnect it with the ignition turned off. Then, use a jump wire to connect both ends of the disconnected yellow connector. Turn the ignition switch to ON - the SRS light will illuminate for a set amount of time and then turn off. Quickly remove one end of the wire just after the light goes off, causing the SRS light to turn on again. Reconnect the wire within four seconds to turn off the light. After four more seconds, disconnect both ends of the wire. The SRS light will blink twice, signaling that you should turn the ignition switch to OFF. Reconnect the yellow connector, and when you next start the Pilot, the SRS light will briefly come on for 6 seconds before being reset.
More answers
-
To clear the SRS light on your 2005 Honda Pilot, first turn the key to the "on" position. Then, remove the light from your dashboard and manipulate the two extended wires by connecting and disconnecting them.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
