Vehicle Questions and Answers

Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!

How do you reset the airbag light on a Ford Fusion?

21012 views

5 answers

★ Top Answer
conrad

The airbag system in your Ford Fusion is designed to keep you safe in case of an accident, so if you notice any issues with it, it's important to investigate. I recommend taking your vehicle to an authorized service center to have the airbag system checked for any faults. If everything seems fine, you can reset the airbag warning light on the dashboard by following these steps: With the vehicle in the on position but the engine not running, observe the airbag light until it goes off, then turn off the car. Repeat this process two more times for a total of three cycles. Once completed, start the engine and the light should stay on for seven seconds before turning off completely.

More answers

  • Russell M.

    Turn on the car's ignition by inserting the key. Allow the airbag warning light to go off. Turn off the ignition again for a brief period of around three seconds. Repeat these steps twice, for a total of three times. Finally, turn the ignition back on to reset the airbag light entirely.

  • Dexter Y.

    I just tapped my dashboard twice and it fixed the issue. Maybe my folks didn't mess up after all.

  • Robin Round

    A problem with the door handle switch circuit caused an error in the TPMS/PATS system during the OBDII scan. I fixed the issue and now the airbag light is off.

  • Angel Gomez

    Hey Ray! Can you help me figure out how to fix the problem I'm having with my 2017 Fusion S where the battery keeps draining? I did some online research and it seems like the issue might be with the DDS (driver door system), specifically the door handle/window controls. This could explain why the rear passenger window doesn't roll up automatically and why holding it down while the car is in park seems to put extra strain on the engine. I read that some cars may need a firmware update to fix this, but it sounds like a complex process. Can you assist me with this?

Buying a Used car?
Check it by Epicvin
  • Safe checkout guaranteed
  • Niada logo
  • Blockchain confirmed data