Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
Sure, here is a paraphrased version: "What's the process for resetting the anti-theft system on my 2006 Chevrolet Equinox?
4788 views
4 answers
★ Top Answer
To reinitialize the security system in the 2006 Chevy Equinox, follow these steps: Insert the key and turn it to the "on" position, then try to start the engine. If the security system has blocked ignition, the vehicle won't start. Wait for about 10 minutes until the flashing "security" light turns off. Turn the key to the "off" position and wait 5 seconds. Try starting the engine again. If the reset is successful, you should be able to drive the car. Repeat this process up to three times to allow the security feature to unlock the engine. Eventually, the Passlock Sensor Data Code will signal the ignition to activate.
More answers
-
To deactivate the theft protection system on your 2006 Chevy Equinox, insert the key slightly in the ignition between off and accessory. Next, push the reset button found on the steering wheel. Once the light turns off, the system should be recalibrated.
-
Here's a revised version: I own a 2006 Chevy Equinox and recently had a remote starter installed. I've noticed that when I use the remote, the car starts intermittently. Sometimes, it goes into a security lock mode and won't start at all. However, I found that jump-starting the vehicle gets it going. Last night, I saw the security light flashing for the first time. After a while, the light stopped and the car started normally. Any advice on this issue would be greatly appreciated.
-
It was unsuccessful.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
