Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
Sure, How do you reset the airbag light on a 2003 Honda Accord?
1598 views
2 answers
★ Top Answer
Resetting the airbag light on your 2003 Honda Accord is a simple task that should only take about 4 to 8 minutes of your time. To start, go to the driver's side of your car and enter. Insert your key into the ignition and turn it to the on position without starting the engine. You will notice the srs light come on briefly and then go off. Walk to the front of your car and disconnect the positive terminal of the battery. Once you see the srs light reappear, return to the battery and reconnect the terminal. This process should reset the airbag light.
More answers
-
To reset the airbag light on a 2003 Honda Accord, follow these steps:
1. Remove the ecu service connector 2 and turn off the ignition switch.
2. Locate the mes connector (a 2-pin yellow connector wrapped in yellow) plugged in the front of the fuse box under the dashboard and link (jump) it.
3. Turn the ignition switch back on.
4. Wait for the airbag light to go out, then the SRS light will come on for 6 seconds before going out. Remove the jumper within 4 seconds.
5. Once the SRS light comes on again, reconnect the jumper within 4 seconds of it switching on.
6. When the SRS light goes out, replace the jumper within 4 seconds of it going out.
7. The SRS light will blink twice to indicate that the memory has been reset.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
