Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
What is the significance of the "service rsc now" message appearing on a 2010 Ford Explorer?
26591 views
12 answers
★ Top Answer
The alert currently activated on the 2010 Ford Explorer is similar to the indicator for engine issues. Unfortunately, there is no way to manually reset this warning signal on the vehicle. It illuminates when there is a problem with the car, but the causes can vary widely. Therefore, it is not recommended to spend time trying to identify a potential minor issue unless it is glaringly obvious. The most effective course of action is to take the vehicle to a professional mechanic who can utilize an OBD tool to scan for trouble codes and pinpoint the exact problem area. Once the issue is identified, it can be resolved, leading to the deactivation of the warning light. However, it is prudent to first check the gas cap and fuel door as a simple oversight in this area can trigger the warning light unnecessarily. This is a minor issue that can be checked independently before seeking assistance from a mechanic.
More answers
-
Every so often, the rsc light in my vehicle illuminates. Is it safe to continue driving with this light on?
-
Is it still possible to operate the vehicle when the RSC light is illuminated?
-
How can I make it leave?
-
Am I still able to operate my vehicle?
-
RSC, short for Roll Stability Control, is a feature that assists in preventing the vehicle from rolling over. If you see the message "SERVICE RSC NOW" appear, it means that the system is experiencing issues. If the warning persists or doesn't disappear, it is recommended to get in touch with your local Ford dealer to address the problem.
-
I had a problem where my car was beeping loudly. It turned out that the issue was caused by my alternator not charging the battery properly. I discovered this when I stopped the car to silence the beeping and it wouldn't start again. After installing a new alternator, the error message disappeared!
-
My dashboard alert for the tire pressure monitoring system illuminated.
-
Press and hold the abs button for one minute. If it works, you're lucky. Next, inspect your abs sensor and replace it if there are any issues. Finally, replace the part if necessary. Before making any changes, release the ABS sensor and then reconnect it in case there's a loose connection.
-
I experienced the same problem with my Explorer, but once I changed the wheel bearing, the RSC light turned off! Hopefully, this solution works for you too!
-
You should replace the ABS Module in your vehicle and then reprogram it after installing the fixed one.
-
I recently had new brake pads, rotors, and stabilizer bars installed on all four tires. However, occasionally the RSC light comes on and the brake system needs to be checked.
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
