Vehicle Questions and Answers

Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!

Where is the blend door actuator located in a 2012 Chrysler 200?

1591 views

5 answers

★ Top Answer
Paul R

The blend door actuator (BDA) for your 2012 Chrysler 200 is located on the passenger side of your vehicle, underneath the glove box in the footwell. To remove it, start by disabling the airbag system and disconnecting the negative battery cable from your battery. Wait a few minutes for the airbag system capacitor to discharge before proceeding. Take out the glove box, and you'll see the actuator positioned behind and slightly below it. Unplug the wire harness connector from the BDA, located on the left side of the housing. Next, remove the two screws that hold the BDA in place, allowing you to pull it forward and up for replacement.

More answers

  • Audi Junkie

    Below the glove compartment are two important components: the recirculating door and the mode door. The heater door blend actuator is situated beneath the steering wheel, positioned above the heater core lines. This actuator is responsible for controlling the movement of an arm that, in turn, operates the heater door.

  • Nanci

    The passenger side does not house the blend door; instead, the recirculation and mode actuators are located there. You can find the blend door on the driver side beneath the steering wheel.

  • Jennifer D

    The blend door actuator for the 2012 Chrysler 200 can be found beneath the glove compartment on the passenger side footwell.

  • Barbara B

    Beneath the bonnet of the vehicle

Buying a Used car?
Check it by Epicvin
  • Safe checkout guaranteed
  • Niada logo
  • Blockchain confirmed data