CHEVROLET CAVALIER Recall Check

Recall #:

95V141000

Recall Date:

1995-07-27

Component(s):

STRUCTURE: FRAME AND MEMBERS

SOME WELDS WERE OMITTED FROM THE BODY LOCK PILLAR, OR "B" PILLAR. THIS DOES NOT COMPLY WITH FMVSS NO.208, "OCCUPANT CRASH PROTECTION."

Recall #:

06E026000

Recall Date:

2006-03-23

Component(s):

EXTERIOR LIGHTING

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Recall #:

09E025000

Recall Date:

2009-05-11

Component(s):

EXTERIOR LIGHTING: HEADLIGHTS

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Recall #:

96V250000

Recall Date:

1996-12-20

Component(s):

EXTERIOR LIGHTING: HAZARD FLASHING WARNING LIGHTS

THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. THIS FAILS TO COMPLY WITH FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Recall #:

06E049000

Recall Date:

2006-06-05

Component(s):

EXTERIOR LIGHTING

CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Recall #:

08E063000

Recall Date:

2008-10-20

Component(s):

STEERING

DORMAN PRODUCTS IS RECALLING 3,900 INTERMEDIATE STEERING SHAFTS DORMAN PART NOS. 425-151, 425-152, AND 425-153, (SOLD UNDER DORMAN'S "OE SOLUTIONS" BRAND NAME), BALKAMP #'S 7-3057, 7-3058, 7-3059 (SOLD UNDER THE "NAPA" BRAND NAME), AND PLATINUM PARTS #'S 2425151, 2425152, AND 2425153 MANUFACTURED DURING THE MONTH OF SEPTEMBER 2007. THESE REPLACEMENT STEERING SHAFTS CAN BE USED ON THE VEHICLES LISTED ABOVE. THE WELD CONNECTING THE INNER TUBE TO THE OUTER TUBE MAY BE DEFECTIVE.

Recall #:

95V025000

Recall Date:

1995-02-21

Component(s):

SUSPENSION: FRONT: CONTROL ARM: LOWER ARM

THESE VEHICLES HAVE BEEN BUILT WITH WELDS MISSING FROM THE FRONT SUSPENSION LOWER CONTROL ARM ASSEMBLIES CAUSING EXCESSIVE LOADS ON THE EXISTING WELDS.

Recall #:

94V115000

Recall Date:

1994-06-28

Component(s):

STEERING: LINKAGES: KNUCKLE: SPINDLE: ARM

THESE VEHICLES WERE BUILT WITH OVERTORQUED DRIVE AXLE SPINDLE NUTS. THIS CONDITION CAN CAUSE EXCESSIVE LOADS ON THE SPINDLE NUT AND DRIVE AXLE RESULTING IN FAILURE OF THE DRIVE AXLE OR THE SPINDLE NUT. FAILURE OF EITHER OF THESE COMPONENTS CAN RESULT IN SEPARATION OF THE STEERING KNUCKLE TIRE-WHEEL ASSEMBLY FROM THE DRIVE AXLE.

Recall #:

96I001000

Recall Date:

1996-03-27

Component(s):

ELECTRICAL SYSTEM: HORN

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THESE VEHICLES WERE BUILT WITH INSUFFICIENT RETENTION OF THE HORN PAD.

Recall #:

93V121000

Recall Date:

1993-07-27

Component(s):

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: HOSES, LINES/PIPING, AND FITTINGS

THE BRAKE HOSES WERE MANUFACTURED INCORRECTLY, AND DO NOT COMPLY WITH FMVSS 106, "BRAKE HOSES."