CHEVROLET LUMINA APV Recall Check

Recall #:

07E021000

Recall Date:

2007-03-12

Component(s):

FUEL SYSTEM, OTHER: STORAGE: TANK ASSEMBLY: PRESSURE RELIEF DEVICES

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

Recall #:

02V286000

Recall Date:

2002-11-06

Component(s):

STEERING: RACK AND PINION

CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.

Recall #:

95V214000

Recall Date:

1995-11-09

Component(s):

VEHICLE SPEED CONTROL

THESE VEHICLES WERE ASSEMBLED WITH THROTTLE CABLE SUPPORT BRACKETS THAT COULD CONTACT THE THROTTLE LEVER SYSTEM AND INHIBIT THE THROTTLE RETURN. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 124, "ACCELERATOR CONTROL SYSTEMS."

Recall #:

95V048000

Recall Date:

1995-03-22

Component(s):

SERVICE BRAKES, HYDRAULIC: PEDALS AND LINKAGES

IMPROPERLY MANUFACTURED BRAKE PEDAL ARM CAUSES THE BRAKE PEDAL ARM TO FRACTURE DURING BRAKING.

Recall #:

96V015000

Recall Date:

1996-01-25

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION: COOLING UNIT AND LINES

VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.

Recall #:

94V100000

Recall Date:

1994-06-20

Component(s):

SEAT BELTS: FRONT: WEBBING

THE SECOND ROW, RIGHT HAND SHOULDER BELT CAN BECOME "PINCHED" BETWEEN THE SEAT AND THE DOOR FRAME PILLAR TRIM. THE SHOULDER BELT MAY NOT RETRACT PROPERLY, WHICH DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION." THE 1994 VEHICLES HAVE AN OPTIONAL INTEGRAL (BUILT IN) CHILDSEAT INSTALLED NEXT TO THE POWER SLIDING SIDE DOOR. THE 1993 INVOLVED VEHICLES HAVE STANDARD SEATS IN THAT SAME POSITION.

Recall #:

94V015000

Recall Date:

1994-01-31

Component(s):

SEAT BELTS: FRONT: RETRACTOR

THE THIRD ROW SAFETY BELT RETRACTORS MAY BE INSTALLED INCORRECTLY AND MAY LOCK-UP WHEN THE VEHICLE IS ON SLOPES OF LESS THAN 15 DEGREES, WHICH DOES NOT COMPLY WITH FMVSS NO. 209, "SEAT BELT ASSEMBLIES."

Recall #:

93V212000

Recall Date:

1993-12-30

Component(s):

SEAT BELTS: REAR/OTHER

THE SAFETY BELT RETRACTORS FOR THE REAR CENTER POSITION ARE MISSING A PAWL SPRING AND IN CASE OF AN ACCIDENT, WILL ALLOW THE SAFETY BELT WEBBING TO EXTEND BEYOND THE MINIMUM REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."

Recall #:

96V015000

Recall Date:

1996-01-25

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION: COOLING UNIT AND LINES

VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.

Recall #:

94V100000

Recall Date:

1994-06-20

Component(s):

SEAT BELTS: FRONT: WEBBING

THE SECOND ROW, RIGHT HAND SHOULDER BELT CAN BECOME "PINCHED" BETWEEN THE SEAT AND THE DOOR FRAME PILLAR TRIM. THE SHOULDER BELT MAY NOT RETRACT PROPERLY, WHICH DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION." THE 1994 VEHICLES HAVE AN OPTIONAL INTEGRAL (BUILT IN) CHILDSEAT INSTALLED NEXT TO THE POWER SLIDING SIDE DOOR. THE 1993 INVOLVED VEHICLES HAVE STANDARD SEATS IN THAT SAME POSITION.