HONDA Recall Check

Recall #:

83V131000

Recall Date:

1983-12-13

Component(s):

LATCHES/LOCKS/LINKAGES: HOOD: LATCH

PRODUCTION TOLERANCE ERRORS COULD ALLOW ACCIDENTAL HOOD OPENING. IF THE HOOD IS NOT SECURELY LATCHED IN THE FULLY LOCKED POSITION, DRIVING AT HIGH SPEED OR HITTING A LARGE BUMP COULD CAUSE THE HOOD TO OPEN WITHOUT WARNING.

Recall #:

83V132000

Recall Date:

1983-12-13

Component(s):

POWER TRAIN: DRIVELINE: DRIVESHAFT

LEFT DRIVE SHAFT MAY DEVELOP CRACKS, AND MAY BREAK UNDER HEAVY LOADING SUCH AS THAT CAUSED BY RAPID ACCELERATION. THIS DEFECT ORIGINATED IN A MANUFACTURING PROCESS WHICH HAS NOW BEEN IMPROVED.

Recall #:

92V028000

Recall Date:

1992-03-25

Component(s):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY: FILLER PIPE AND CAP

IF THE PLASTIC COATING OF THE FUEL FILLER AND/OR BREATHER PIPE IS DAMAGED, SALT WATER MAY ACCUMULATE BETWEEN THE PLASTIC COATING AND THE STEEL PIPES, AND THE ACCUMULATION COULD CAUSE CORROSSION WHICH WOULD EVENTUALLY RUST THROUGH THE AFFECTED PIPES, ALLOWING GASOLINE FUMES AND FUEL TO LEAK.

Recall #:

92V028001

Recall Date:

1993-04-26

Component(s):

FUEL SYSTEM, GASOLINE

IF THE PLASTIC COATING OF THE FUEL FILLER AND/OR BREATHER PIPE IS DAMAGED, SALT WATER MAY ACCUMULATE BETWEEN THE PLASTIC COATING AND THE STEEL PIPES, AND THE ACCUMULATION COULD CAUSE CORROSION WHICH WOULD EVENTUALLY RUST THROUGH THE AFFECTED PIPES, ALLOWING GASOLINE FUMES AND FUEL TO LEAK.

Recall #:

83V090000

Recall Date:

1983-10-12

Component(s):

STEERING: STEERING WHEEL/HANDLE BAR

HANDLEBAR TUBE AND HANDLEBAR ARM DO NOT FIT SECURELY BECAUSE THE INSIDE DIAMETER OF THE HANDLEBAR TUBE IS INCORRECT. THIS CAUSES STRESS TO BEAR DIRECTLY ON A PIN.

Recall #:

85V120000

Recall Date:

1985-11-08

Component(s):

ELECTRICAL SYSTEM: ALTERNATOR/GENERATOR/REGULATOR

THE KICKSTAND SYSTEM MAY EXPERIENCE SOME ENGINE KICKBACK DUE TO IMPROPER STARTING PROCEDURE. CONSEQUENCE OF DEFECT: FAILURE TO FOLLOW PROPER STARTING PROCEDURES MAY RESULT IN INJURY TO THE RIDERS LEG.

Recall #:

82V071000

Recall Date:

1982-07-28

Component(s):

STRUCTURE: BODY

THE REAR WHEEL FENDER AIR CLEANING MOUNTING BRACKETS COULD CRACK DUE TO ENGINE VIBRATIONS OVER A PERIOD OF TIME. BOLTS WHICH SECURE THE FENDER COULD LOOSEN AND THE FENDER COULD CONTACT THE REAR TIRE, CAUSING WHEEL LOCK-UP.

Recall #:

84V164000

Recall Date:

1985-01-07

Component(s):

ELECTRICAL SYSTEM: WIRING: FRONT UNDERHOOD

WIRE IN BATTERY CHARGING CIRCUIT CANNOT TOLERATE THE MAXIMUM CURRENT DRAWN BY THE ALTERNATOR. UNDER REPEATED HIGH ELECTRICAL LOAD, HEAT WILL BUILD UP AT CONNECTOR TERMINAL AREA, MELTING THE PLASTIC WIRE HARNESS, POSSIBLY DISCHARGING BATTERY.

Recall #:

92V028000

Recall Date:

1992-03-25

Component(s):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY: FILLER PIPE AND CAP

IF THE PLASTIC COATING OF THE FUEL FILLER AND/OR BREATHER PIPE IS DAMAGED, SALT WATER MAY ACCUMULATE BETWEEN THE PLASTIC COATING AND THE STEEL PIPES, AND THE ACCUMULATION COULD CAUSE CORROSSION WHICH WOULD EVENTUALLY RUST THROUGH THE AFFECTED PIPES, ALLOWING GASOLINE FUMES AND FUEL TO LEAK.

Recall #:

84V086000

Recall Date:

1984-08-03

Component(s):

STRUCTURE: FRAME AND MEMBERS

THE SPRINGS ARE HELD UP BY A METAL SUPPORT AROUND EACH SHOCK ABSORBER. VEHICLES DRIVEN REGULARLY IN AREAS WHERE ROADS ARE SALTED DURING WINTERTIME ARE SUBJECT TO RUSTING OF THESE SUPPORTS. RUSTING MAY EVENTUALLY ALLOW THE SPRING TO BREAK THROUGH THE SUPPORT.