HYUNDAI ACCENT Recall Check

Recall #:

97V026000

Recall Date:

1997-03-03

Component(s):

VISIBILITY: WINDSHIELD WIPER/WASHER: MOTOR

THE WINDSHIELD WIPER MOTOR CIRCUIT BREAKER ELECTRICAL CONTACTS WERE CONTAMINATED DURING ASSEMBLY.

Recall #:

02V341000

Recall Date:

2003-01-06

Component(s):

SUSPENSION: FRONT: CONTROL ARM: LOWER ARM

ON CERTAIN PASSENGER VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA. DURING WINTER MONTHS, LARGE QUANTITIES OF SALT ARE USED TO DE-ICE ROADS. THIS ROAD SALT COULD RESULT IN CORROSION OF THE FRONT LOWER CONTROL ARMS.

Recall #:

96V113000

Recall Date:

1996-07-08

Component(s):

SUSPENSION: FRONT: CONTROL ARM: LOWER ARM

THROUGH CONTACT WITH ROAD HAZARDS AND CURBS, THE LOWER CONTROL ARM ASSEMBLY CAN SHIFT FROM ITS ORIGINAL POSITION.

Recall #:

95V043000

Recall Date:

1995-03-06

Component(s):

ELECTRICAL SYSTEM: WIRING: INTERIOR/UNDER DASH

THE ENGINE CONTROL MODULE WIRING HARNESS UNDER THE INSTRUMENT PANEL CAN BE CONTACTED BY THE CLUTCH PEDAL ASSEMBLY WHEN THE CLUTCH IS ENGAGED.

Recall #:

98V245000

Recall Date:

1998-10-07

Component(s):

SUSPENSION: FRONT: SPRINGS: COIL SPRINGS

VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING "SALT BELT" STATES: CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, AND WISCONSIN. DURING WINTER MONTHS, THE ROAD SALT USED TO DE-ICE ROADS CAN RESULT IN CORROSION THAT CAUSES PITS TO FORM ON THE LOWER COIL OF THE FRONT SPRINGS ALLOWING CRACKS TO DEVELOP. THIS CAN RESULT IN BREAKAGE OF THE LOWER SPRING COIL.

Recall #:

95V003000

Recall Date:

1995-01-24

Component(s):

EXTERIOR LIGHTING: HEADLIGHTS: HIGH/LOW BEAM DIMMER SWITCH

A PLASTIC SLIDER PIECE WITHIN THE HEADLAMP DIMMER SWITCH ASSEMBLY DOES NOT FULLY RETRACT WHEN THE HEADLAMP DIMMER SWITCH IS MOVED FROM LOW BEAM TO HIGH BEAM POSITION. THE LOW BEAM LAMPS GO OUT AS INTENDED, BUT THE HIGH BEAM LAMPS DO NOT COME ON.