HYUNDAI EXCEL Recall Check

Recall #:

93V192000

Recall Date:

1993-12-01

Component(s):

FUEL SYSTEM, GASOLINE

THE VEHICLES FAILED THE LATERAL MOVING BARRIER IMPACT TEST REQUIREMENTS OF FMVSS 301, "FUEL SYSTEM INTEGRITY." THE FUEL LEAKAGE FROM THE GAS TANK EXCEEDED THE MAXIMUM ALLOWABLE AMOUNT OF SPILLAGE.

Recall #:

94V090000

Recall Date:

1994-05-23

Component(s):

ELECTRICAL SYSTEM: ALTERNATOR/GENERATOR/REGULATOR

IN SOME VEHICLES, THE MANUFACTURER'S PROTECTIVE INTERNAL COATING OF THE ELECTRONIC CRANK ANGLE SENSOR DOES NOT MEET SPECIFICATIONS, WHICH CAN CAUSE AN OPEN CIRCUIT AT HIGH OPERATING TEMPERATURES. THIS CAN CAUSE THE VEHICLE TO STALL.

Recall #:

93V192000

Recall Date:

1993-12-01

Component(s):

FUEL SYSTEM, GASOLINE

THE VEHICLES FAILED THE LATERAL MOVING BARRIER IMPACT TEST REQUIREMENTS OF FMVSS 301, "FUEL SYSTEM INTEGRITY." THE FUEL LEAKAGE FROM THE GAS TANK EXCEEDED THE MAXIMUM ALLOWABLE AMOUNT OF SPILLAGE.

Recall #:

93V192000

Recall Date:

1993-12-01

Component(s):

FUEL SYSTEM, GASOLINE

THE VEHICLES FAILED THE LATERAL MOVING BARRIER IMPACT TEST REQUIREMENTS OF FMVSS 301, "FUEL SYSTEM INTEGRITY." THE FUEL LEAKAGE FROM THE GAS TANK EXCEEDED THE MAXIMUM ALLOWABLE AMOUNT OF SPILLAGE.

Recall #:

93V192000

Recall Date:

1993-12-01

Component(s):

FUEL SYSTEM, GASOLINE

THE VEHICLES FAILED THE LATERAL MOVING BARRIER IMPACT TEST REQUIREMENTS OF FMVSS 301, "FUEL SYSTEM INTEGRITY." THE FUEL LEAKAGE FROM THE GAS TANK EXCEEDED THE MAXIMUM ALLOWABLE AMOUNT OF SPILLAGE.

Recall #:

93V192000

Recall Date:

1993-12-01

Component(s):

FUEL SYSTEM, GASOLINE

THE VEHICLES FAILED THE LATERAL MOVING BARRIER IMPACT TEST REQUIREMENTS OF FMVSS 301, "FUEL SYSTEM INTEGRITY." THE FUEL LEAKAGE FROM THE GAS TANK EXCEEDED THE MAXIMUM ALLOWABLE AMOUNT OF SPILLAGE.

Recall #:

90V053000

Recall Date:

1990-03-28

Component(s):

WHEELS: HUBCAP/COVER

LOCK WASHER LOCATED UNDER THE NUT THAT SECURES THE FRONT HUB TO THE DRIVE SHAFT MAY HAVE HAD IMPROPER HEAT TREATMENT AND COULD CRACK.

Recall #:

94V103000

Recall Date:

1994-06-23

Component(s):

VISIBILITY: DEFROSTER/DEFOGGER/HVAC SYSTEM: HEATER CORE

THE HEATER CONTROL VALVE STEM DOES NOT MEET THE MATERIAL SPECIFICATIONS. HIGH COOLANT TEMPERATURES CAN CAUSE THE STEM TO LEAK.

Recall #:

89V100000

Recall Date:

1989-07-23

Component(s):

VEHICLE SPEED CONTROL

IF CRUISE CONTROL MAIN SWITCH IS IN THE ON POSITION WHEN ENGINE IS STARTED, SYSTEM CAN BE AFFECTED BY A SHORT DURATION VOLTAGE DROP CAUSED BY OPTIONAL HI-POWER (H340) RADIO.

Recall #:

91V225000

Recall Date:

1992-01-06

Component(s):

ENGINE AND ENGINE COOLING: EXHAUST SYSTEM

DETERIORATION OF THE REED VALVE SUBASSEMBLY MAY LEAD TO A MALFUNCTION WITHIN THE SECONDARY AIR SUPPLY PORTION OF THE EMISSION CONTROL SYSTEM. THE SCREWS WHICH ATTACH THE REEDS TO THE REED VALVE SUBASSEMBLY MAY RUST, AND IF THE RUSTING BECOMES SEVERE, THE SCREW HEADS WILL ERODE AND ALLOW THE REEDS TO SEPARATE FROM THE REED VALVE SUBASSEMBLY. CORROSION MAY ALSO OCCUR ON THE REED VALVE SUBASSEMBLY, DEFORMING THE REED SEATS AND PREVENTING THE REEDS FROM CLOSING PROPERLY. SEPARATION OF THE REEDS FROM THE REED VALVE SUBASSEMBLY OR IMPROPER CLOSING OF THE REEDS ALLOW HOT EXHAUST GASES TO FLOW BACKWARD INTO THE PLASTIC SECONDARY AIR FILTER CASE WHEN THE VEHICLE IS BEING DRIVEN. THESE HOT EXHAUST GASES MAY MELT THE SECONDARY PLASTIC AIR FILTER CASE.