LINCOLN Recall Check

Recall #:

78V201000

Recall Date:

1979-10-12

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION

THESE TRANSMISSIONS MAY CONTAIN IMPROPERLY MANUFACTURED PARKING PAWL ACTUATING RODS. CONSEQUENTLY, THE UNHARDENED CAM SURFACE OF THESE RODS CAN ALLOW THE ROD TO DEFORM DURING USE WITH RESULTANT INCREASE IN SHIFT EFFORTS AND DIFFICULTY IN RELEASING THE PARKING PAWL AND ENGAGING THE PARKING GEAR.

Recall #:

79V117000

Recall Date:

1979-10-12

Component(s):

SERVICE BRAKES, HYDRAULIC: PEDALS AND LINKAGES

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Recall #:

79V117000

Recall Date:

1979-10-12

Component(s):

SERVICE BRAKES, HYDRAULIC: PEDALS AND LINKAGES

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Recall #:

79V117000

Recall Date:

1979-10-12

Component(s):

SERVICE BRAKES, HYDRAULIC: PEDALS AND LINKAGES

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Recall #:

81V008000

Recall Date:

1981-02-12

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION: GEAR POSITION INDICATION (PRNDL)

THIS IS A MANUFACTURER"S NOTICE TO ADVISE OWNERS OF PROPER VEHICLE OPERATION. THE PARKING GEAR MAY NOT BE SECURELY ENGAGED AFTER THE OPERATOR HAS ATTEMPTED TO SHIFT TO PARK. THE VEHICLE MAY APPEAR TO BE IN PARK THOUGH ACTUALLY IN REVERSE. THIS COULD ALLOW THE VEHICLE TO MOVE UNEXPECTEDLY.

Recall #:

78V256000

Recall Date:

1979-10-12

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION

THE INVOLVED VEHICLES WERE EQUIPPED WITH AUTOMATIC TRANSMISSIONS IN WHICH THE PARKING PAWL WAS NOT HEAT-TREATED. DURING NORMAL VEHICLE OPERATION, A PARKING PAWL THAT HAS NOT BEEN HEAT-TREATED COULD BECOME DEFORMED OR WORN TO THE POINT THAT THE TRANSMISSION WILL NOT LOCK IN "PARK". AS A RESULT, THE VEHICLE COULD ROLL FREE IF THE DRIVER DOES NOT SET THE PARKING BRAKE WHEN PARKING OR LEAVING VEHICLE UNATTENDED.

Recall #:

77V210000

Recall Date:

1979-10-12

Component(s):

VEHICLE SPEED CONTROL

THE ELECTRONIC ENGINE CONTROL (EEC) WIRING HARNESS MAY BE MISROUTED. THIS MISROUTING MAY CAUSE THE SPEED CONTROL SERVO ARM TO BE HELD OPEN DUE TO MECHANICAL INTERFERENCE WHEN THE SPEED CONTROL IS ENGAGED. THIS CAUSES A PARTIALLY OPEN THROTTLE CONDITION THAT CANNOT BE CANCELLED BY DRIVER ACTIONS NORMALLY USED TO SHUT OFF THE SPEED CONTROL SYSTEM.

Recall #:

79V249000

Recall Date:

1979-12-14

Component(s):

STRUCTURE: BODY: BUMPERS

THE INVOLVED VEHICLES WERE BUILT WITH AN ALUMINUM REAR BUMPER REINFORCEMENT ATTACHED TO TWO STEEL MOUNTING SURFACES. IN CLIMATES WHERE LARGE AMOUNTS OF ROCK SALT ARE USED, THE ALUMINUM REINFORCEMENT COULD EXPERIENCE CORROSION WHERE IT ATTACHES TO THE VEHICLE.

Recall #:

77V185000

Recall Date:

1979-10-12

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION: LEVER AND LINKAGE: COLUMN SHIFT

ON THE INVOLVED VEHICLES, THE PARK ACTUATION SUPPORT PLATES ARE DEFECTIVE DUE TO THEIR SUSCEPTIBILITY TO CRACKING DUE TO IMPROPER HEAT TREATMENT DURING MANUFACTURE. AS A RESULT, FRAGMENTS FROM A BROKEN PLATE CAN BECOME LODGED IN THE TRANSMISSION PARKING PAWL MECHANISM. THIS COULD PREVENT THE TRANSMISSION PARKING PAWL FROM ENGAGING WHEN THE SELECTOR LEVER IS PLACED IN THE "PARK" POSITION, OR PREVENT THE PAWL FROM BEING DISENGAGED FROM THE PARK GEAR.

Recall #:

81V008000

Recall Date:

1981-02-12

Component(s):

POWER TRAIN: AUTOMATIC TRANSMISSION: GEAR POSITION INDICATION (PRNDL)

THIS IS A MANUFACTURER"S NOTICE TO ADVISE OWNERS OF PROPER VEHICLE OPERATION. THE PARKING GEAR MAY NOT BE SECURELY ENGAGED AFTER THE OPERATOR HAS ATTEMPTED TO SHIFT TO PARK. THE VEHICLE MAY APPEAR TO BE IN PARK THOUGH ACTUALLY IN REVERSE. THIS COULD ALLOW THE VEHICLE TO MOVE UNEXPECTEDLY.