2005 NISSAN MURANO Recall Check

Recall #:

06V054000

Recall Date:

2006-02-22

Component(s):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY

ON CERTAIN SPORT UTILITY VEHICLES, A FITTING FOR VAPOR RECIRCULATION, WHICH IS WELDED ON THE FUEL TANK, MAY COME OFF THE FUEL TANK BECAUSE INCORRECT MATERIAL WAS USED.

Recall #:

06V048000

Recall Date:

2006-02-14

Component(s):

SEAT BELTS: REAR/OTHER

ON SOME SPORT UTILITY VEHICLES, IN CERTAIN HIGH SPEED FRONTAL CRASHES, THE WEBBING OF A REAR OUTBOARD SEAT BELT MAY CONTACT THE REAR SEAT BACK HINGE WHERE IT CAN BE CUT BY THE SHARP EDGE OF THE METAL PORTION OF THE HINGE.

Recall #:

06V003000

Recall Date:

2006-01-10

Component(s):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY

ON CERTAIN SPORT UTILITY VEHICLES, DUE TO THE LOCATION OF THE FORWARD EDGE OF THE FUEL TANK, IN THE EVENT THAT A VEHICLE FRONT TIRE RUNS OVER A SMALL, SHARP OBJECT IN THE ROAD, CATCHES IT AND PROPELS IT TOWARDS THE REAR OF THE VEHICLE, IT MAY STRIKE AND PUNCTURE THE FUEL TANK.

Recall #:

05V319000

Recall Date:

2005-07-14

Component(s):

ELECTRICAL SYSTEM: ALTERNATOR/GENERATOR/REGULATOR

ON CERTAIN SPORT UTILITY VEHICLES, THERE IS A POSSIBILITY THAT A WIRE BREAKING INSIDE THE ALTERNATOR COULD STOP THE BATTERY FROM CHARGING.

Recall #:

06V401000

Recall Date:

2006-10-20

Component(s):

STEERING: COLUMN LOCKING: ANTI-THEFT DEVICE

CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." DURING AN INSPECTION OF SOME VEHICLES AT THE ASSEMBLY PLANT, IT WAS FOUND THAT THE STEERING WHEEL WAS LOCKED WITH THE IGNITION KNOB IN THE "OFF" POSITION BUT THE VEHICLE TRANSMISSION NOT BEING IN THE "PARK" POSITION.

Recall #:

09V169000

Recall Date:

2009-05-19

Component(s):

ENGINE AND ENGINE COOLING

NISSAN IS RECALLING 362,891 MY 2003-2007 MURANO VEHICLES. THE INTAKE AIR DUCTS, WHICH ARE CONNECTED TO THE INTERMEDIATE RESONATOR IN THE AIR INTAKE SYSTEM OF THE ENGINE, MAY SEPARATE FROM THE RESONATOR WITH ENGINE MOVEMENT. THIS SEPARATION OCCURS DUE TO THE PREMATURE AGING OF THE MATERIAL USED IN THE INTAKE AIR DUCTS WHICH CAUSES EXCESSIVE SHRINKING.