SUBARU Recall Check

Recall #:

90V086000

Recall Date:

1990-05-23

Component(s):

SUSPENSION: REAR

CONTINUOUS EXPOSURE TO ROAD SALT COULD CAUSE CORROSION OF REAR SUSPENSION COMPONENTS, ESPECIALLY THE INNER ARMS.

Recall #:

90V086000

Recall Date:

1990-05-23

Component(s):

SUSPENSION: REAR

CONTINUOUS EXPOSURE TO ROAD SALT COULD CAUSE CORROSION OF REAR SUSPENSION COMPONENTS, ESPECIALLY THE INNER ARMS.

Recall #:

83V026000

Recall Date:

1983-03-11

Component(s):

ELECTRICAL SYSTEM: WIRING: FUSES AND CIRCUIT BREAKERS

THE DEFECT INVOLVES THE 25 AMP HEADLIGHT FUSE HOLDER. THERE MAY BE EXCESSIVE ELECTRICAL RESISTANCE CAUSED BY THE LOOSENESS OF THE RIVET HOLDING THE FUSE HOLDER TO THE TERMINAL PLATE. EXCESS RESISTANCE MAY CAUSE THE SOLDERED END OF THE FUSE TO MELT. AN OPEN CIRCUIT COULD OCCUR AND THE HEADLIGHTS WOULD NOT OPERATE.

Recall #:

80V077000

Recall Date:

1980-07-29

Component(s):

VISIBILITY: WINDSHIELD WIPER/WASHER: LINKAGES

WHEN WIPER BLADES ARE FROZEN TO THE WINDSHIELD AND THE WIPER MOTOR IS TURNED ON, THE RIGHT-HAND WIPER PIVOT MAY BECOME BENT. THE PLASTIC BEARING, WHICH IS A SNAP-ON DEVICE FITTING OVER THE BALL JOINT ON THE DRIVE MOTOR, MAY PULL OFF THE BALL, DISENGAGING THE WIPER SYSTEM, MAKING BOTH WIPERS INOPERATIVE.

Recall #:

84V026000

Recall Date:

1984-04-04

Component(s):

STEERING: RACK AND PINION

A PROTECTIVE BOOT COVERING THE STEERING RACK AND PINION SHAFT CAN COME LOOSE IN EXTREME COLD. WHEN UNPROTECTED, THE RACK SHAFT MAY CORRODE, RESULTING IN HARD OR STIFF STEERING.

Recall #:

83V006000

Recall Date:

1983-02-04

Component(s):

SEATS: FRONT ASSEMBLY: RECLINER

THE INTERNAL SEATBACK FRAME STRUCTURE MAY BREAK AND SEPARATE FROM THE SEAT.

Recall #:

90V086000

Recall Date:

1990-05-23

Component(s):

SUSPENSION: REAR

CONTINUOUS EXPOSURE TO ROAD SALT COULD CAUSE CORROSION OF REAR SUSPENSION COMPONENTS, ESPECIALLY THE INNER ARMS.

Recall #:

90V086000

Recall Date:

1990-05-23

Component(s):

SUSPENSION: REAR

CONTINUOUS EXPOSURE TO ROAD SALT COULD CAUSE CORROSION OF REAR SUSPENSION COMPONENTS, ESPECIALLY THE INNER ARMS.

Recall #:

83V026000

Recall Date:

1983-03-11

Component(s):

ELECTRICAL SYSTEM: WIRING: FUSES AND CIRCUIT BREAKERS

THE DEFECT INVOLVES THE 25 AMP HEADLIGHT FUSE HOLDER. THERE MAY BE EXCESSIVE ELECTRICAL RESISTANCE CAUSED BY THE LOOSENESS OF THE RIVET HOLDING THE FUSE HOLDER TO THE TERMINAL PLATE. EXCESS RESISTANCE MAY CAUSE THE SOLDERED END OF THE FUSE TO MELT. AN OPEN CIRCUIT COULD OCCUR AND THE HEADLIGHTS WOULD NOT OPERATE.

Recall #:

78V181000

Recall Date:

1979-10-12

Component(s):

FUEL SYSTEM, GASOLINE: STORAGE: TANK ASSEMBLY

A TUBE IN THE FUEL EVAPORATIVE EMISSION CONTROL SYSTEM CAN BECOME OBSTRUCTED, CAUSING EXCESSIVE PRESSURE TO BUILD UP IN THE FUEL TANK. THIS USUALLY OCCURS IN EXTREMELY HIGH TEMPERATURES OR INTENSE SUNLIGHT. EXCESSIVE PRESSURE BUILD-UP CAUSES THE FUEL TANK TO BULGE. A SHORT HAIRLINE CRACK MAY DEVELOP AND FUEL LEAKAGE MAY RESULT.