FORD Recall Check

Recall #:

77V187000

Recall Date:

1979-10-12

Component(s):

STEERING: LINKAGES: TIE ROD ASSEMBLY

ON THE INVOLVED VEHICLES, THE STEERING TIE ROD AND LINK ASSEMBLIES WITH ADJUSTING SLEEVE CLAMPS MAY HAVE BEEN IMPROPERLY MANUFACTURED. THE CLAMPS CONTAIN A SHARP DIE MARK WHICH COULD CAUSE THE CLAMP TO FRACTURE WHEN THE CLAMP BOLT IS TIGHTENED TO SPECIFICATIONS. THE CLAMP COULD BREAK AND CAUSE SEPARATION OF THE TIE ROD ADJUSTING SLEEVES.

Recall #:

80V167000

Recall Date:

1981-01-13

Component(s):

SERVICE BRAKES, HYDRAULIC: FOUNDATION COMPONENTS: HOSES, LINES/PIPING, AND FITTINGS

SOME OF THE SUBJECT VEHICLES MAY HAVE BEEN BUILT WITH FRONT WHEEL BRAKE HOSES THAT ARE TOO LONG. THIS MAY MAKE IT POSSIBLE FOR THE BRAKE HOSE TO CONTACT A FRONT TIRE DURING A FULL LEFT OR RIGHT TURN, WHICH COULD RESULT IN CHAFING OF THE BRAKE HOSE AND SUBSEQUENT BRAKE FLUID LEAKAGE.

Recall #:

78V108000

Recall Date:

1979-10-12

Component(s):

SEAT BELTS: FRONT: RETRACTOR

THE INVOLVED VEHICLES ARE EQUIPPED WITH SHOULDER HARNESS RETRACTORS THAT MAY NOT LOCK. SHOULD THE VEHICLE EXPERIENCE A SUDDEN DECELERATION OR IMPACT, THE FRONT SEAT OCCUPANT MAY NOT BE RESTRAINED BY THE SHOULDER HARNESS PORTION OF THE THREE-POINT SEAT BELT SYSTEM. FURTHERMORE, THE SHOULDER HARNESS RETRACTORS MAY NOT ALLOW EXTRACTION OF THE SHOULDER BELT WEBBING DUE TO A PRE-LOCKED CONDITION. THIS IS A NON-COMPLIANCE TO THE EMERGENCY LOCKING RETRACTOR PERFORMANCE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES".

Recall #:

07E064000

Recall Date:

2007-08-24

Component(s):

FUEL SYSTEM, GASOLINE: DELIVERY: FUEL PUMP

CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

Recall #:

78V108000

Recall Date:

1979-10-12

Component(s):

SEAT BELTS: FRONT: RETRACTOR

THE INVOLVED VEHICLES ARE EQUIPPED WITH SHOULDER HARNESS RETRACTORS THAT MAY NOT LOCK. SHOULD THE VEHICLE EXPERIENCE A SUDDEN DECELERATION OR IMPACT, THE FRONT SEAT OCCUPANT MAY NOT BE RESTRAINED BY THE SHOULDER HARNESS PORTION OF THE THREE-POINT SEAT BELT SYSTEM. FURTHERMORE, THE SHOULDER HARNESS RETRACTORS MAY NOT ALLOW EXTRACTION OF THE SHOULDER BELT WEBBING DUE TO A PRE-LOCKED CONDITION. THIS IS A NON-COMPLIANCE TO THE EMERGENCY LOCKING RETRACTOR PERFORMANCE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES".

Recall #:

78V108000

Recall Date:

1979-10-12

Component(s):

SEAT BELTS: FRONT: RETRACTOR

THE INVOLVED VEHICLES ARE EQUIPPED WITH SHOULDER HARNESS RETRACTORS THAT MAY NOT LOCK. SHOULD THE VEHICLE EXPERIENCE A SUDDEN DECELERATION OR IMPACT, THE FRONT SEAT OCCUPANT MAY NOT BE RESTRAINED BY THE SHOULDER HARNESS PORTION OF THE THREE-POINT SEAT BELT SYSTEM. FURTHERMORE, THE SHOULDER HARNESS RETRACTORS MAY NOT ALLOW EXTRACTION OF THE SHOULDER BELT WEBBING DUE TO A PRE-LOCKED CONDITION. THIS IS A NON-COMPLIANCE TO THE EMERGENCY LOCKING RETRACTOR PERFORMANCE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES".

Recall #:

78V108000

Recall Date:

1979-10-12

Component(s):

SEAT BELTS: FRONT: RETRACTOR

THE INVOLVED VEHICLES ARE EQUIPPED WITH SHOULDER HARNESS RETRACTORS THAT MAY NOT LOCK. SHOULD THE VEHICLE EXPERIENCE A SUDDEN DECELERATION OR IMPACT, THE FRONT SEAT OCCUPANT MAY NOT BE RESTRAINED BY THE SHOULDER HARNESS PORTION OF THE THREE-POINT SEAT BELT SYSTEM. FURTHERMORE, THE SHOULDER HARNESS RETRACTORS MAY NOT ALLOW EXTRACTION OF THE SHOULDER BELT WEBBING DUE TO A PRE-LOCKED CONDITION. THIS IS A NON-COMPLIANCE TO THE EMERGENCY LOCKING RETRACTOR PERFORMANCE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES".

Recall #:

78V023000

Recall Date:

1979-10-12

Component(s):

WHEELS

SOME OF THE STEEL WHEELS ON THE INVOLVED VEHICLES MAY HAVE BEEN IMPROPERLY MANUFACTURED. THESE WHEELS, OVER A PERIOD OF TIME, COULD CRACK IN THE WHEEL RIM AREA THROUGH NORMAL OPERATION, WITHOUT PRIOR WARNING.

Recall #:

78V109000

Recall Date:

1979-10-12

Component(s):

STEERING: LINKAGES

THESE VEHICLES MAY BE EQUIPPED WITH STEERING LINKAGES ON WHICH COTTER PINS MAY NOT HAVE BEEN INSTALLED ON CASTELLATED NUTS TO SECURE THE STEERING DRAG LINK AND TIE-ROD CONNECTIONS. ALSO, THESE ATTACHING NUTS MAY NOT HAVE BEEN TIGHTENED TO SPECIFICATIONS. THIS COULD ALLOW LINKAGE SEPARATION.

Recall #:

78V023000

Recall Date:

1979-10-12

Component(s):

WHEELS

SOME OF THE STEEL WHEELS ON THE INVOLVED VEHICLES MAY HAVE BEEN IMPROPERLY MANUFACTURED. THESE WHEELS, OVER A PERIOD OF TIME, COULD CRACK IN THE WHEEL RIM AREA THROUGH NORMAL OPERATION, WITHOUT PRIOR WARNING.